Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM3090E _53 Suspension _008765 REAR SUSPENSION _0049359 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 48540 2.REMOVE REAR SHOCK ABSORBER ASSEMBLY LH

a.
C129671

Support the rear No. 2 suspension arm with a jack using a wooden block to avoid damage.

NOTICE:

Do not excessively jack up the rear No. 2 suspension arm assembly LH.


HINT:

Support the rear shock absorber at a position where it compresses by approximately 20 to 30 mm (0.788 to 1.181 in.).



b.
C229148

Remove the 2 bolts and disconnect the shock absorber with the rear shock absorber bracket.


c.
C127561

Remove the nut and bolt from the shock absorber upper side.


d.

Remove the shock absorber from the vehicle.


Hide 48517A 3.REMOVE REAR SHOCK ABSORBER BRACKET LH

a.
C278706

Remove the nut and bolt from the bracket.