Home › Suspension › REAR SUSPENSION › REAR UPPER ARM
RM3090E _53 Suspension _008765 REAR SUSPENSION _0049361 REAR UPPER ARM A

REAR SUSPENSION  REAR UPPER ARM  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 89516D 2.DISCONNECT SKID CONTROL SENSOR WIRE LH

a.
C129672

Remove the 2 nuts and disconnect the skid control sensor wire from the rear upper control arm.


Hide 48790 3.REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH

C129670

a.

Using a jack and wooden block, raise the vehicle and hold the rear No. 2 suspension arm assembly LH together with the rear axle carrier at the standard vehicle height.


b.
C127557

Remove the 2 bolts, 2 nuts and upper control arm.

NOTICE:

Since a stopper nut is used, remove the bolt.