Home › Suspension › REAR SUSPENSION › REAR LOWER ARM
RM3090E _53 Suspension _008765 REAR SUSPENSION _0049362 REAR LOWER ARM G

REAR SUSPENSION  REAR LOWER ARM  INSPECTION  


PROCEDURE

Hide 48720A 1.INSPECT REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

C229152

a.

Inspect the turning torque of the ball joint.

i.

Install the installation nut to the ball joint stud.


ii.

Move the stud back and forth 5 times. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.

Standard turning torque:

0.5 to 3.4 N*m (5.1 to 35 kgf*cm, 4.4 to 30 in.*lbf)


If the turning torque is not within the specified range, replace the rear No. 1 suspension arm with a new one.



b.

Check the dust boots for cracks or grease leakage.