Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR
RM3090E _53 Suspension _008765 REAR SUSPENSION _0049364 REAR STABILIZER BAR A

REAR SUSPENSION  REAR STABILIZER BAR  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 89408C 2.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Automatic Headlight Beam Level Control System)

Hide 48840A 3.REMOVE REAR STABILIZER LINK ASSEMBLY LH

a.
C129662

Remove the 2 nuts and 2 cushions and disconnect the link from the No. 2 suspension arm.

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.



Hide 48830D 4.REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 52296 5.REMOVE REAR SUSPENSION MEMBER BRACE LH

C129663

a.

Remove the 2 bolts and member brace from the suspension member.


Hide 48740F 6.LOOSEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

C266840

a.

Loosen the 2 bolts of the suspension arm.

NOTICE:
·

Do not remove the bolts and nuts, only loosen them.

·

Since a stopper nut is used, loosen the bolt.




Hide 48231B 7.REMOVE REAR COIL SPRING LH

a.
C129671

Support the No. 2 suspension arm LH with a jack.

NOTICE:

Place a wooden or rubber block between the jack and arm.



b.
C129668

Remove the bolt located on the rear axle carrier of the rear No. 2 suspension arm.


c.

Lower the jack gradually to remove the rear coil spring together with the rear upper coil spring insulator.


Hide 48259A 8.REMOVE REAR UPPER COIL SPRING INSULATOR LH

a.

Remove the rear upper coil spring insulator from the rear coil spring.


Hide 48258C 9.REMOVE REAR LOWER COIL SPRING INSULATOR LH

a.

Remove the rear lower coil spring insulator from the rear No. 2 suspension arm.


Hide 48812 10.REMOVE REAR STABILIZER BAR

C129664

a.

Remove the 4 bolts and 2 stabilizer brackets from the suspension member.


b.

Remove the stabilizer bar from the suspension member.


Hide 48818 11.REMOVE REAR STABILIZER BUSHING

a.

Remove the 2 rear stabilizer bushes from the rear stabilizer bar.