These DTCs are stored when a malfunction occurs in the instrument panel integration antenna assembly (telephone antenna) circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1573 | Short in Telephone Antenna Circuit | There is a short circuit in the instrument panel integration antenna assembly between the telephone transceiver assembly and telephone antenna, or at the points where it connects to the telephone transceiver assembly and instrument panel integration antenna assembly. | ·
Telephone transceiver assembly ·
Instrument panel integration antenna assembly (telephone antenna) |
| B15CB | Telematics Transceiver Antenna Disconnected | There is an open circuit in the instrument panel integration antenna assembly between the telephone transceiver assembly and telephone antenna, or at the points where it connects to the telephone transceiver assembly and instrument panel integration antenna assembly. | ·
Telephone transceiver assembly ·
Instrument panel integration antenna assembly (telephone antenna) |
When replacing the telephone transceiver assembly or instrument panel integration antenna assembly, refer to the Service Bulletin.
When the telephone transceiver assembly is replaced, it is necessary to set the contract mode.
Turn the ignition switch off.
Check that the connectors are properly connected to the telephone transceiver assembly and instrument panel integration antenna assembly (telephone antenna connector).
Connectors are properly connected.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Turn the ignition switch off.
Disconnect the instrument panel integration antenna assembly (telephone antenna) connector [color: blue].
Check that the connector pins are not bent.
| Proceed to |
|---|
| Connector pins are not bent |
| Connector pins are bent |
Connector pins are not bent
Connector pins are bent
| *1 | Core wire |
| *2 | Shield |
Disconnect the instrument panel integration antenna assembly (telephone antenna) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Core wire - Shield | Always | 4 to 11 kΩ |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Wiggle the instrument panel integration antenna assembly (telephone antenna).
Check for DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR
DTC B1573 and B15CB are not output.
| Proceed to |
|---|
| DTC B1573 and B15CB are not output |
| DTC B1573 and B15CB are output |
DTC B1573 and B15CB are not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTC B1573 and B15CB are output
Temporarily replace the instrument panel integration antenna assembly with a new or normally functioning one.
Refer to the Service Bulletin.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC B1573 and B15CB are not output |
| DTC B1573 and B15CB are output |
DTC B1573 and B15CB are not output
DTC B1573 and B15CB are output