Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › BLOCKING SYSTEM › 2012.12–2015.10
RM3090E _58 Vehicle Interior _008690 THEFT DETERRENT / KEYLESS ENTRY _0048167 BLOCKING SYSTEM C

THEFT DETERRENT / KEYLESS ENTRY  BLOCKING SYSTEM  B15C0  Short in GPS Antenna  B15C1  Open in GPS Antenna  


DESCRIPTION

These DTCs are stored when a malfunction occurs in the instrument panel integration antenna assembly (GPS antenna) circuit.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15C0 Short in GPS Antenna There is a short circuit in the instrument panel integration antenna assembly between the telephone transceiver assembly and instrument panel integration antenna assembly (GPS antenna), or at the points where it connects to the telephone transceiver assembly and instrument panel integration antenna assembly.
·

Telephone transceiver assembly

·

Instrument panel integration antenna assembly (GPS antenna)


B15C1 Open in GPS Antenna There is an open circuit in the instrument panel integration antenna assembly between the telephone transceiver assembly and instrument panel integration antenna assembly (GPS antenna), or at the points where it connects to the telephone transceiver assembly and instrument panel integration antenna assembly.
·

Telephone transceiver assembly

·

Instrument panel integration antenna assembly (GPS antenna)



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the telephone transceiver assembly or instrument panel integration antenna assembly, refer to the Service Bulletin.

·

When the telephone transceiver assembly is replaced, it is necessary to set the contract mode.



PROCEDURE

1.CHECK CONNECTION OF CONNECTORS
a.

Turn the ignition switch off.


b.

Check that the connectors are properly connected to the telephone transceiver assembly and instrument panel integration antenna assembly (GPS antenna).

OK:

Connectors are properly connected.



Result:
Proceed to
OK
NG



OK

2.CLEAR DTC

NG

CONNECT CONNECTORS CORRECTLY

2.CLEAR DTC
a.

Clear the DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR

Body Electrical > Telematics > Clear DTCs
50002 233

Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR

Body Electrical > Telematics > Trouble Codes
50001 233

Result:
Proceed to
DTC B15C0 and B15C1 are not output
DTC B15C0 and B15C1 are output



DTC B15C0 and B15C1 are output

4.CHECK CONNECTOR CONDITION

DTC B15C0 and B15C1 are not output

4.CHECK CONNECTOR CONDITION
a.

Turn the ignition switch off.


b.

Disconnect the instrument panel integration antenna assembly (GPS antenna) connector [color: gray].


c.

Check that the connector pins are not bent.


Result:
Proceed to
Connector pins are not bent
Connector pins are bent



Connector pins are not bent

5.CHECK INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY

Connector pins are bent

REPAIR OR REPLACE INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY

5.CHECK INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY
a.
B330777C01
2.396,0.969 2.198,0.969 2.198,0.969 1.729,1.229 false 2.458,1.708 2.229,1.708 2.229,1.708 1.792,1.365 false 2.458,0.906 2.771,1.063 0.313,0.156 10 *1 2.521,1.635 2.833,1.792 0.313,0.156 10 *2
*1 Core wire
*2 Shield


Disconnect the instrument panel integration antenna assembly (GPS antenna) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Core wire - Shield Always 50 to 500 Ω



Result:
Proceed to
OK
NG



OK

6.CLEAR DTC

NG

REPLACE INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY

6.CLEAR DTC
a.

Clear the DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR

Body Electrical > Telematics > Clear DTCs
50002 233

Result:
Proceed to
NEXT



NEXT

7.CHECK FOR DTC
7.CHECK FOR DTC
a.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR

Body Electrical > Telematics > Trouble Codes
50001 233

Result:
Proceed to
DTC B15C0 and B15C1 are not output
DTC B15C0 and B15C1 are output



DTC B15C0 and B15C1 are not output

DTC B15C0 and B15C1 are output

8.REPLACE INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY
8.REPLACE INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY
a.

Temporarily replace the instrument panel integration antenna assembly with a new or normally functioning

HINT:

Refer to the Service Bulletin.



Result:
Proceed to
NEXT



NEXT

9.CLEAR DTC
9.CLEAR DTC
a.

Clear the DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR

Body Electrical > Telematics > Clear DTCs
50002 233

Result:
Proceed to
NEXT



NEXT

10.CHECK FOR DTC
10.CHECK FOR DTC
a.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR

OK:

DTC B15C0 and B15C1 is not output.



Result:
Proceed to
DTC B15C0 and B15C1 are not output
DTC B15C0 and B15C1 are output



DTC B15C0 and B15C1 are not output

END (INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY WAS DEFECTIVE)

DTC B15C0 and B15C1 are output

REPLACE TELEPHONE TRANSCEIVER ASSEMBLY