Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM
RM3090E _58 Vehicle Interior _008690 THEFT DETERRENT / KEYLESS ENTRY _0048165 THEFT DETERRENT SYSTEM C

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  B2761  Intrusion Sensor Internal Circuit Malfunction  


DESCRIPTION

The intrusion sensor (theft warning ultrasonic sensor) conducts self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).

If a problem is detected in the signals transmitted and received by the intrusion sensor (theft warning ultrasonic sensor), or if the transmission or reception circuits malfunction, the intrusion sensor (theft warning ultrasonic sensor) transmits a signal to the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) then stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area
B2761 Intrusion Sensor Internal Circuit Malfunction Intrusion sensor (theft warning ultrasonic sensor) outputs signal for sensor malfunction
·

Map light assembly

·

Intrusion sensor (theft warning ultrasonic sensor)

·

Main body ECU (multiplex network body ECU)



CAUTION / NOTICE / HINT

NOTICE:

When replacing the main body ECU (multiplex network body ECU), make sure to replace it with a new one.


PROCEDURE

1.CHECK FOR DTC
a.

Clear the DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Clear DTCs
50002 123

b.

Turn the ignition switch to ON, then off.


c.

Set the theft deterrent system to "ARMED STATE".


d.

Check that the security indicator changes from illuminated to blinking.


e.

Set the theft deterrent system to "DISARMED STATE".


f.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Trouble Codes
50001 123

Result:
Proceed to
DTC B2761 is not output
DTC B2761 is output



DTC B2761 is not output

DTC B2761 is output

2.REPLACE MAP LIGHT ASSEMBLY
2.REPLACE MAP LIGHT ASSEMBLY
a.

Temporarily replace the map light assembly with a new or normally functioning one.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>INTRUSION SENSOR>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Clear the DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Clear DTCs
50002 123

b.

Turn the ignition switch to ON, then off.


c.

Set the theft deterrent system to "ARMED STATE".


d.

Check that the security indicator changes from illuminated to blinking.


e.

Set the theft deterrent system to "DISARMED STATE".


f.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Trouble Codes
50001 123

Result:
Proceed to
DTC B2761 is not output
DTC B2761 is output



DTC B2761 is not output

END (MAP LIGHT ASSEMBLY WAS DEFECTIVE)

DTC B2761 is output

4.REPLACE INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR)
4.REPLACE INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR)
a.

Temporarily replace the intrusion sensor (theft warning ultrasonic sensor) with a new or normally functioning one.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>INTRUSION SENSOR>REMOVAL


Result:
Proceed to
NEXT



NEXT

5.CHECK DTC
5.CHECK DTC
a.

Clear the DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Clear DTCs
50002 123

b.

Turn the ignition switch to ON, then off.


c.

Set the theft deterrent system to "ARMED STATE".


d.

Check that the security indicator changes from illuminated to blinking.


e.

Set the theft deterrent system to "DISARMED STATE".


f.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Trouble Codes
50001 123

Result:
Proceed to
DTC B2761 is not output
DTC B2761 is output



DTC B2761 is not output

END (INTRUSION SENSOR [THEFT WARNING ULTRASONIC SENSOR] WAS DEFECTIVE)

DTC B2761 is output

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)