When there is a short to GND in the power supply for the transponder key amplifier of the engine switch, the certification ECU (smart key ECU assembly) stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B278A | Short to GND in Immobiliser System Power Source Circuit | A short to GND in the power supply of the transponder key amplifier of the engine switch (VC5 - VC5) (1 trip detection logic*). | ·
Harness or connector ·
Engine switch ·
Certification ECU (smart key ECU assembly) |
DTC Output Confirmation Operation:
With the shift lever in P (except Manual Transaxle), the key is held near the engine switch and an engine start operation is performed by pressing and holding the engine switch when the key battery is depleted. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started when key battery is depleted by holding key near engine switch and pressing and holding engine switch with shift lever in P (except Manual Transaxle) | - |
| DTC No. | Data List and Active Test |
|---|---|
| B278A | - |
Before replacing the certification ECU (smart key ECU assembly), refer to the Service Bulletin.
After performing repairs, perform the DTC output confirmation operation, and then confirm that no DTCs are output again.
Disconnect the G84 certification ECU (smart key ECU assembly) connector.
Disconnect the G24 engine switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G84-1 (VC5) - G24-10 (VC5) | Always | Below 1 Ω |
| G84-24 (AGND) - G24-6 (AGND) | Always | Below 1 Ω |
| G84-1 (VC5) - Body ground | Always | 10 kΩ or higher |
| G24-10 (VC5) - Body ground | Always | 10 kΩ or higher |
| G84-24 (AGND) - Body ground | Always | 10 kΩ or higher |
| G24-6 (AGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Reconnect the G24 engine switch and G84 certification ECU (smart key ECU assembly) connector.
| *a | Component with harness connected
(Engine Switch) |
Using an oscilloscope, check the waveform.
Perform this inspection on the engine switch side.
| Item | Content |
|---|---|
| Tester Connection | G24-10 (VC5) - G24-6 (AGND) |
| Tool Setting | 2 V/DIV., 200 ms./DIV. |
| Condition | Engine switch off, key not in cabin, within 30 seconds after engine switch pressed |
Waveform is output normally (refer to illustration).
| Proceed to |
|---|
| OK (for 2AR-FE) |
| OK (for 3ZR-FAE) |
| OK (for 3ZR-FE) |
| OK (for 1AD-FTV) |
| OK (for 2AD-FTV) |
| OK (for 2AD-FHV) |
| NG |
OK (for 2AR-FE)
OK (for 3ZR-FAE)
OK (for 3ZR-FE)
OK (for 1AD-FTV)
OK (for 2AD-FTV)
OK (for 2AD-FHV)
NG