Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › IMMOBILISER SYSTEM(w/ Entry and Start System)
RM3090E _58 Vehicle Interior _008690 THEFT DETERRENT / KEYLESS ENTRY _0048164 IMMOBILISER SYSTEM(w/ Entry and Start System) C

THEFT DETERRENT / KEYLESS ENTRY  IMMOBILISER SYSTEM(w/ Entry and Start System)  B2790  ID BOX EEPROM Malfunction  


DESCRIPTION

When an internal malfunction occurs in the ID code box (immobiliser code ECU), the certification ECU (smart key ECU assembly) stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B2790 ID BOX EEPROM Malfunction An internal malfunction occurs in the ID code box (immobiliser code ECU) (EEPROM access malfunction) (1 trip detection logic*).
·

ID code box (immobiliser code ECU)

·

Certification ECU (smart key ECU assembly)


DTC output confirmation operation:
An immobiliser set/unset operation is performed (the engine switch is turned off or on [IG] while carrying the key).

*: Only output while a malfunction is present.

Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation when Malfunction Detected
·

Engine running: Engine cannot be started next time

·

Engine stopped: Engine cannot be started


-

Related Data List and Active Test
DTC No. Data List and Active Test
B2790 -

CAUTION / NOTICE / HINT

NOTICE:
·

Before replacing the certification ECU (smart key ECU assembly) or ID code box (immobiliser code ECU), refer to the Service Bulletin.

·

After performing repair, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.



PROCEDURE

1.REPLACE ID CODE BOX (IMMOBILISER CODE ECU)
a.

Replace the ID code box (immobiliser code ECU) with a new one.

HINT:

Refer to the Service Bulletin.



Result:
Proceed to
NEXT



NEXT

2.CLEAR DTC
2.CLEAR DTC
a.

Clear the DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM(w/ Entry and Start System)>DTC CHECK / CLEAR

Body Electrical > Entry&Start > Clear DTCs
50002 125

Result:
Proceed to
NEXT



NEXT

3.REGISTER RECOGNITION CODES
3.REGISTER RECOGNITION CODES
a.

Register the recognition codes in the ECUs.

HINT:

Refer to the Service Bulletin.



Result:
Proceed to
NEXT



NEXT

4.REGISTER ECU COMMUNICATION ID
4.REGISTER ECU COMMUNICATION ID
a.

Register the recognition codes in the ECUs.

HINT:

Refer to the Service Bulletin.



Result:
Proceed to
NEXT



NEXT

5.CHECK FOR DTC
5.CHECK FOR DTC
a.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM(w/ Entry and Start System)>DTC CHECK / CLEAR

HINT:

Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.


Body Electrical > Entry&Start > Trouble Codes
50001 125

Result:
Proceed to
DTC B2790 is not output
DTC B2790 is output



DTC B2790 is not output

END (ID CODE BOX [IMMOBILISER CODE ECU] WAS DEFECTIVE)

DTC B2790 is output

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)