Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0048746 LANE DEPARTURE ALERT SYSTEM C

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  C1AA0  Front Camera Module Circuit  


DESCRIPTION

This DTC indicates an internal malfunction of the lane departure warning camera.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AA0 Front Camera Module Circuit While the ignition switch is ON, the lane departure warning camera detects an internal malfunction for 5 seconds or more. Lane departure warning camera

CAUTION / NOTICE / HINT

NOTICE:

When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera beam axis must be performed.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT


PROCEDURE

1.CLEAR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Enter the following menus: Chassis / Lane Departure Alert / Trouble Codes / Clear DTCs.


d.

Clear the DTCs.

Chassis > Lane Departure Alert > Clear DTCs
50002 355

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle at a speed between 50 km/h (32 mph) and 220 km/h (138 mph), and operate the lane departure alert system.



b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Enter the following menus: Chassis / Lane Departure Alert / Trouble Codes.


e.

Check for DTCs.

Chassis > Lane Departure Alert > Trouble Codes
50001 355

Result:
Proceed to
No DTCs are output
DTC C1AA0 is output



No DTCs are output

DTC C1AA0 is output