When the lane departure warning camera is replaced with a new one, it acquires the country specification information from the main body ECU (multiplex network body ECU). When the country specification information in the lane departure warning camera and main body ECU (multiplex network body ECU) do not match, DTC C1AA1 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AA1 | FCM Destination Information Unmatched | While the initial check is running, the ignition switch is ON and the lane departure alert system is operating, country specification information in the lane departure warning camera and main body ECU (multiplex network body ECU) do not match for 1 second or more. | ·
Lane departure warning camera ·
Main body ECU (multiplex network body ECU) |
When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera beam axis must be performed.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT
The lane departure alert system uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the lane departure alert system after confirming that the communication systems are functioning properly.
Perform the lane departure warning camera adjustment.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Chassis / Lane Departure Alert / Trouble Codes / Clear DTCs.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Perform the following to make sure the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed between 50 km/h (32 mph) and 220 km/h (138 mph), and operate the lane departure alert system.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Chassis / Lane Departure Alert / Trouble Codes.
Check for DTCs.
| Proceed to |
|---|
| No DTCs are output |
| DTC C1AA1 is output |
No DTCs are output
DTC C1AA1 is output
Replace the main body ECU (multiplex network body ECU) with a new one.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for LHD)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Perform the lane departure warning camera adjustment.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Chassis / Lane Departure Alert / Clear DTCs.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Perform the following to make sure the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed between 50 km/h (32 mph) and 220 km/h (138 mph), and operate the lane departure alert system.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Chassis / Lane Departure Alert / Trouble Codes.
Check for DTCs.
| Proceed to |
|---|
| No DTCs are output |
| DTC C1AA1 is output |
No DTCs are output
DTC C1AA1 is output