If the lane departure warning camera determines that the lane departure warning camera axis has deviated, DTC C1AA8 is stored. Also, if the camera sensor beam axis adjustment is not performed after installing the lane departure warning camera, DTC C1AA9 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AA8 | Front Camera Module Incorrect Axial Gap | While the ignition switch is ON and the lane departure alert system is operating, the lane departure warning camera detects lane departure warning camera beam axis deviation. | Lane departure warning camera |
| C1AA9 | Front Camera Module Beam Axis Not Adjusted | While the ignition switch is ON, the lane departure warning camera detects that lane departure warning camera adjustment has not been completed. | Lane departure warning camera |
When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera beam axis must be performed.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT
Perform the lane departure warning camera adjustment.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Chassis / Lane Departure Alert / Trouble Codes / Clear DTCs.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
If the detection conditions are not met, the system cannot detect the malfunction.
Turn the ignition switch to ON.
Enter the following menus: Chassis / Lane Departure Alert / Trouble Codes.
Check for DTCs.
| Proceed to |
|---|
| No DTCs are output |
| DTC C1AA8 and/or C1AA9 are output |
No DTCs are output
DTC C1AA8 and/or C1AA9 are output