Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMBUSTION TYPE POWER HEATER SYSTEM
RM3090E _58 Vehicle Interior _008789 HEATING / AIR CONDITIONING _0049438 COMBUSTION TYPE POWER HEATER SYSTEM J

HEATING / AIR CONDITIONING  COMBUSTION TYPE POWER HEATER SYSTEM  ECU Power Source Circuit  


DESCRIPTION

This is power source circuit for the heater assembly.

WIRING DIAGRAM

E267053
0.958,0.917 1.833,1.167 0.875,0.25 10 from Battery 3.479,1.083 4.354,1.333 0.875,0.25 10 STV HTR 5.563,0.823 5.76,1.042 0.198,0.219 10 5 5.563,1.813 5.76,2.031 0.198,0.219 10 1 5.75,1.927 5.948,2.146 0.198,0.219 10 E 5.76,0.958 6.281,1.219 0.521,0.26 10 B 5.531,2.844 6.052,3.104 0.521,0.26 10 A33 5.542,3 6.729,3.302 1.188,0.302 10 Heater Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (HEATER ASSEMBLY - BATTERY AND BODY GROUND)
a.
E267497C01
1.5,0.208 1.896,0.448 0.396,0.24 1.458,1.5 1.031,1.75 1.031,1.75 0.76,1.75 true 1.448,1.208 0.99,1.104 0.99,1.104 0.719,1.104 true 1.563,0.26 2.021,0.458 0.458,0.198 10 A33 0.052,0.052 0.51,0.25 0.458,0.198 10 *a 0.563,1.031 0.75,1.229 0.188,0.198 10 E 0.615,1.667 0.823,1.875 0.208,0.208 10 B
*a Front view of wire harness connector
(to Heater Assembly)


Disconnect the heater assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A33-1 (E) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A33-5 (B) - Body ground Always 11 to 14 V



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR