Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMBUSTION TYPE POWER HEATER SYSTEM
RM3090E _58 Vehicle Interior _008789 HEATING / AIR CONDITIONING _0049438 COMBUSTION TYPE POWER HEATER SYSTEM D

HEATING / AIR CONDITIONING  COMBUSTION TYPE POWER HEATER SYSTEM  SYSTEM DESCRIPTION  


GENERAL


a.

While the AD engines offer excellent combustion efficiency, it generates less heat. Therefore, depending on the operating condition, the engine coolant temperature remains low, making it difficult to ensure the proper heating effect. Thus, in order to provide adequate heating effect, a combustion type power heater is provided as optional equipment on the cold area specification.


b.

This heater system provides a combustion type power heater between the engine and the heater core. Air and fuel are introduced into the heater's combustion chamber, and a glow plug is used to ignite this mixture. By heating the water that flows around the combustion chamber, this system ensures the heating effect.

E183958
0.635,4.979 1.75,5.323 1.115,0.344 10 : Engine Coolant 0.635,5.323 1.063,5.708 0.427,0.385 10 : Fuel 2.563,1.781 3.302,2.115 0.74,0.333 10 Fuel Pump Filter 0.615,2.354 1.51,2.688 0.896,0.333 10 Common Rail 1.771,2.198 2.25,2.75 0.479,0.552 10 Supply Pump 1.219,3.115 1.74,3.5 0.521,0.385 10 Engine 2.563,4.073 3.229,4.448 0.667,0.375 10 Intake Air 4.938,4.073 5.792,4.427 0.854,0.354 10 Exhaust Gas 3.51,1.844 4.698,2.167 1.188,0.323 10 Heater Fuel Pump 5.677,1.375 6.375,1.729 0.698,0.354 10 Fuel Tank 6.26,3.75 7.115,4.146 0.854,0.396 10 Heater Core 3.719,2.75 4.5,3.385 0.781,0.635 10 Combustion Chamber



HEATER ASSEMBLY


a.

This system, which consists of a heater assembly, heater switch assembly, and a heater pump assembly, operates when the engine is running and the heater switch assembly is turned on.

·

The heater assembly consists of an ECU, flame sensor, surface sensor, control overheating sensor, glow plug, and air blower motor. It cannot be disassembled.

·

The ECU in the heater assembly controls this system in accordance with the signals received from the sensors and switches.


E181249
1.042,2.375 1.042,0.833 1.042,0.833 0.938,0.833 false 1.771,2.729 1.771,0.615 1.771,0.615 1.646,0.615 false 2.396,3.052 3.125,2.458 3.125,2.458 3.25,2.458 false 2.521,3.115 3.573,3.875 3.573,3.875 3.74,3.875 false 2.771,3.427 3.531,4.292 3.531,4.292 3.677,4.292 false 3.896,5.396 3.594,6.188 3.594,6.188 3.813,6.188 false 1.885,5.354 1.979,5.615 1.979,5.615 2.115,5.615 false 1.698,3.635 1.313,4.594 1.313,4.594 1.458,4.594 false 0.302,0.75 1.01,1.083 0.708,0.333 10 Air Blower Motor 1.333,0.531 1.688,0.708 0.354,0.177 10 ECU 3.5,1.448 4.146,1.625 0.646,0.177 10 Intake Air 3.26,2.385 5.094,2.563 1.833,0.177 10 Control Overheating Sensor 3.667,2.927 5.25,3.208 1.583,0.281 10 Heater Switch Assembly 6.063,2.438 6.948,2.698 0.885,0.26 10 Heater Core 5.927,4.073 6.406,4.365 0.479,0.292 10 Engine 3.781,3.792 4.792,4.01 1.01,0.219 10 Surface Sensor 3.698,4.219 4.74,4.427 1.042,0.208 10 Heat Exchanger 4.635,5.729 5.51,6 0.875,0.271 10 Exhaust Gas 3.854,6.115 6.104,6.313 2.25,0.198 10 Exhaust Pipe 1.948,7 3.469,7.208 1.521,0.208 10 Heater Pump Assembly 2.156,5.531 2.646,5.698 0.49,0.167 10 Muffler 1.49,4.51 2.896,4.677 1.406,0.167 10 Combustion Chamber

E177180
3.854,0.854 4.521,0.26 false 3.865,1.802 4.469,1.292 false 2.625,1.563 3.125,2.021 false 3.125,0.635 2.542,0.49 false 2.771,0.063 3.104,0.219 0.333,0.156 10 Fuel 1.927,0.417 2.542,0.635 0.615,0.219 10 Fuel Pipe 4.583,0.188 5.781,0.625 1.198,0.438 10 Air Blower Motor 4.51,1.188 5.208,1.385 0.698,0.198 10 Glow Plug 1.74,1.458 2.646,1.646 0.906,0.188 10 Flame Sensor



OPERATION


a.

When the engine is operating, turning the heater switch assembly on causes the air blower motor to operate for several seconds for verification purposes. Then, the glow plug starts to preheat the combustion chamber. After that, the fuel pump and air blower motor turn on in order to start low combustion. The fuel pump speed is then increased in steps, and this is accompanied by a gradual increase in the speed of the air blower motor, thus leading to high combustion.


b.

When the ignition switch is turned off or the heater switch assembly is turned off, the fuel pump stops, causing the combustion to stop. For the purpose of after-purge, current is applied again to the glow plug, and the air blower motor is activated for several seconds. Then, the entire system comes to stop.

E145177
1.51,5.802 1.792,6.083 false 0.146,0.135 1.219,0.344 1.073,0.208 12 Timing Chart: 2.333,0.76 2.813,1.042 0.479,0.281 10 Igniting 4.167,0.781 5.031,1.052 0.865,0.271 10 Hi → Lo → Hi 5.625,0.781 6.531,1.052 0.906,0.271 10 Extinguishing 0.177,1.427 1.063,1.833 0.885,0.406 10 Heater Switch Assembly 0.188,2.531 0.99,2.865 0.802,0.333 10 Glow Plug 0.188,3.74 0.979,4.177 0.792,0.438 10 Air Blower Motor Speed 1.188,1.313 1.385,1.552 0.198,0.24 10 On 1.188,2.333 1.385,2.542 0.198,0.208 10 On 1.188,1.792 1.406,1.979 0.219,0.188 10 Off 1.188,2.99 1.385,3.219 0.198,0.229 10 Off 1.198,4.365 1.417,4.563 0.219,0.198 10 Off 1.177,5.646 1.385,5.813 0.208,0.167 10 Off 0.198,4.969 0.885,5.396 0.688,0.427 10 Fuel Pump Speed 1.146,3.604 1.469,3.833 0.323,0.229 10 High 1.146,5.063 1.479,5.25 0.333,0.188 10 High 1.833,6.073 1.979,6.292 0.146,0.219 10 6 6.5,5.979 7.135,6.292 0.635,0.313 10 (Second) 1.594,2.083 1.781,2.323 0.188,0.24 10 10 4.229,3.375 4.427,3.573 0.198,0.198 10 10 4.771,3.385 4.969,3.583 0.198,0.198 10 10 2.25,3.385 2.448,3.583 0.198,0.198 10 10 2.792,3.385 2.99,3.583 0.198,0.198 10 40 2.844,4.844 3.042,5.042 0.198,0.198 10 40 2.688,2.073 2.958,2.292 0.271,0.219 10 100 6.198,3.396 6.49,3.594 0.292,0.198 10 100 5.417,2.073 5.646,2.323 0.229,0.25 10 20 5.417,3.396 5.708,3.594 0.292,0.198 10 20 2.156,4.844 2.448,5.042 0.292,0.198 10 20 1.594,3.396 1.76,3.583 0.167,0.188 10 5 2.135,3.677 2.302,3.865 0.167,0.188 10 5 3.344,3.385 3.51,3.573 0.167,0.188 10 5 4.76,4.844 4.927,5.031 0.167,0.188 10 5 3.333,4.844 3.5,5.031 0.167,0.188 10 5 1.74,3.677 1.958,3.958 0.219,0.281 10 12 1.76,4.844 1.979,5.083 0.219,0.24 10 15 1.99,3.385 2.146,3.552 0.156,0.167 10 8


c.

While the system is in operation, it controls the fuel pump speed and switches high combustion and low combustion, and always keeps the coolant temperature between 67°C (152.6°F) and 80°C (176°F). If the coolant temperature exceeds 80°C (176°F), the fuel pump stops automatically to stop the combustion. Thereafter, when the coolant temperature reaches 67°C (152.6°F) or below, ignition occurs again. The operation of the glow plug, air blower motor and fuel pump during extinguishing and re-igniting is the same as when these are operated by switch as mentioned previously.

E181250
0.042,0.083 2.292,0.323 2.25,0.24 12 Coolant Temperature Control: 1.198,0.521 2.385,0.688 1.188,0.167 10 Combustion Mode 2.063,0.927 2.396,1.115 0.333,0.188 10 High 2.073,1.354 2.385,1.51 0.313,0.156 10 Low 2.146,1.74 2.396,1.896 0.25,0.156 10 Off 2.927,2.135 3.104,2.281 0.177,0.146 10 67 2.698,2.406 3.125,2.563 0.427,0.156 10 152.6 3.417,2.135 3.625,2.302 0.208,0.167 10 72 3.198,2.406 3.604,2.563 0.406,0.156 10 161.6 3.635,2.135 3.833,2.313 0.198,0.177 10 75 3.656,2.406 3.917,2.594 0.26,0.188 10 167 4.219,2.135 4.406,2.323 0.188,0.188 10 80 4.146,2.406 4.406,2.573 0.26,0.167 10 176 4.844,2.042 6.25,2.229 1.406,0.188 10 Coolant Temperature 4.5,2.135 4.813,2.323 0.313,0.188 10 (°C) 4.51,2.396 4.802,2.573 0.292,0.177 10 (°F)