Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMBUSTION TYPE POWER HEATER SYSTEM
RM3090E _58 Vehicle Interior _008789 HEATING / AIR CONDITIONING _0049438 COMBUSTION TYPE POWER HEATER SYSTEM C

HEATING / AIR CONDITIONING  COMBUSTION TYPE POWER HEATER SYSTEM  050  Detection of No Ignition  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
050 Detection of No Ignition The ECU is locked as a result of 10 successive heater ignition failures.
·

Intake air duct

·

Exhaust air duct

·

Fuel pump filter

·

Heater pump assembly

·

Heater assembly



CAUTION / NOTICE / HINT

HINT:

Clear the DTCs by pressing the memory clear buttons on the DTC tester to unlock the ECU.


PROCEDURE

1.INSPECT INTAKE AIR DUCT
a.

Inspect the intake air duct.

OK:

There is no problem with the intake air duct.



Result:
Result Proceed to
There is no problem with the intake air duct A
The intake air duct is clogged, or other problems are found B



A

2.INSPECT EXHAUST AIR DUCT

B

CLEAN OR REPLACE INTAKE AIR DUCT

2.INSPECT EXHAUST AIR DUCT
a.

Inspect the exhaust air duct.


Result:
Result Proceed to
There is no problem with the exhaust air duct A
The exhaust air duct is clogged, or other problems are found B



A

3.INSPECT HEATER PUMP ASSEMBLY

B

CLEAN OR REPLACE EXHAUST AIR DUCT

3.INSPECT HEATER PUMP ASSEMBLY
a.
E267500N01
2.438,1.625 2.198,1.625 2.198,1.625 1.896,1.219 false 0.948,1.615 1.146,1.615 1.146,1.615 1.573,1.208 false 2.5,1.552 2.813,1.75 0.313,0.198 10 B2 0.688,1.531 1,1.729 0.313,0.198 10 E2

Remove the heater pump assembly.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (B2) - 2 (E2) Always 9 to 12 Ω



c.

Inspect heater pump assembly operation.

i.

Connect a positive (+) lead from the battery to terminal 1 (B2) and a negative (-) lead to terminal 2 (E2), and check the pressure of the hose by hand.

NOTICE:

This inspection must be done quickly (within 10 seconds) to prevent damage to the heater pump assembly.


OK:

The pressure is applied to the hose.




Result:
Proceed to
OK
NG



OK

4.CHECK FUEL PUMP FILTER

NG

4.CHECK FUEL PUMP FILTER
a.

Replace the fuel pump filter with a new one and check that the condition returns to normal.

OK:

The heater is ignited normally and starts operating.



Result:
Proceed to
OK
NG



OK

END (FUEL PUMP FILTER IS DEFECTIVE)

NG