| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| 052 | Safety Time Exceeded | A heater ignition failure is detected. | ·
Exhaust air duct ·
Intake air duct ·
Fuel pump filter ·
Heater pump assembly ·
Heater assembly |
Inspect the intake air duct.
| Result | Proceed to |
|---|---|
| There is no problem with the intake air duct | A |
| The intake air duct is clogged, or other problems are found | B |
A
B
Inspect the exhaust air duct.
| Result | Proceed to |
|---|---|
| There is no problem with the exhaust air duct | A |
| The exhaust air duct is clogged, or other problems are found | B |
A
B
Remove the heater pump assembly.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>HEATER FUEL PUMP>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (B2) - 2 (E2) | Always | 9 to 12 Ω |
Inspect heater pump assembly operation.
Connect a positive (+) lead from the battery to terminal 1 (B2) and a negative (-) lead to terminal 2 (E2), and check the pressure of the hose by hand.
This inspection must be done quickly (within 10 seconds) to prevent damage to the heater pump assembly.
The pressure is applied to the hose.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the fuel pump filter with a new one and check that the condition returns to normal.
The heater is ignited normally and starts operating.
| Proceed to |
|---|
| OK |
| NG |
OK
NG