Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMBUSTION TYPE POWER HEATER SYSTEM
RM3090E _58 Vehicle Interior _008789 HEATING / AIR CONDITIONING _0049438 COMBUSTION TYPE POWER HEATER SYSTEM C

HEATING / AIR CONDITIONING  COMBUSTION TYPE POWER HEATER SYSTEM  054  High Setting of Flame Cutout  056  Low Setting of Flame Cutout  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
054 High Setting of Flame Cutout Combustion ends abnormally (High output operation).
·

Exhaust air duct

·

Intake air duct

·

Fuel pump filter

·

Heater pump assembly

·

Heater assembly


056 Low Setting of Flame Cutout Combustion ends abnormally (Low output operation).
·

Exhaust air duct

·

Intake air duct

·

Fuel pump filter

·

Heater pump assembly

·

Heater assembly



CAUTION / NOTICE / HINT

HINT:

Before performing the following procedure, attempt to restart the heater assembly. If the heater assembly is successfully started, confirm that neither DTC 054 nor DTC 056 is output. If neither DTC 054 nor 056 is output, finish troubleshooting because it can be concluded that the system has returned to normal operation.


PROCEDURE

1.INSPECT INTAKE AIR DUCT
a.

Inspect the intake air duct.


Result:
Result Proceed to
There is no problem with the intake air duct A
The intake air duct is clogged, or other problems are found B



A

2.INSPECT EXHAUST AIR DUCT

B

CLEAN OR REPLACE INTAKE AIR DUCT

2.INSPECT EXHAUST AIR DUCT
a.

Inspect the exhaust air duct.

Result:
Result Proceed to
There is no problem with the exhaust air duct A
The exhaust air duct is clogged, or other problems are found B




A

3.INSPECT HEATER PUMP ASSEMBLY

B

CLEAN OR REPLACE EXHAUST AIR DUCT

3.INSPECT HEATER PUMP ASSEMBLY
a.
E267500N01
2.438,1.625 2.198,1.625 2.198,1.625 1.896,1.219 false 0.948,1.615 1.146,1.615 1.146,1.615 1.573,1.208 false 2.5,1.552 2.813,1.75 0.313,0.198 10 B2 0.688,1.531 1,1.729 0.313,0.198 10 E2

Remove the heater pump assembly connector.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>HEATER FUEL PUMP>REMOVAL


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (B2) - 2 (E2) Always 9 to 12 Ω



c.

Inspect heater pump assembly operation.

i.

Connect a positive (+) lead from the battery to terminal 1 (B2) and a negative (-) lead to terminal 2 (E2), and check the pressure of the hose by hand.

NOTICE:

This inspection must be done quickly (within 10 seconds) to prevent damage to the heater pump assembly.


OK:

The pressure is applied to the hose.




Result:
Proceed to
OK
NG



OK

4.CHECK FUEL PUMP FILTER

NG

4.CHECK FUEL PUMP FILTER
a.

Replace the fuel filter with a new one and check that the condition returns to normal.

OK:

The heater is ignited normally and starts operating.



Result:
Proceed to
OK
NG



OK

END (FUEL PUMP FILTER IS DEFECTIVE)

NG