Use the following procedure to troubleshoot the combustion type power heater system.
*: Use the DTC tester.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Inspect the battery voltage with the ignition switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and note any codes that are output.
Clear the DTCs.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Refer to Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
A
B
Terminals of ECU.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>COMBUSTION TYPE POWER HEATER SYSTEM>TERMINALS OF ECU
Inspection
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT