Home › Vehicle Exterior › DOOR / HATCH › HOOD
RM3090E _59 Vehicle Exterior _008794 DOOR / HATCH _0049512 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

HINT:
·
B286201
0.654,1.73 0.831,1.9 0.177,0.17 10 *1 2.553,1.73 2.73,1.9 0.177,0.17 10 *2
*1 Centering Bolt
*2 Standard Bolt


Centering bolts are used to mount the hood hinge to the vehicle body and hood. The hood cannot be adjusted with the centering bolts on. Substitute the centering bolts for standard bolts (with washers) when making adjustments.

·

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 53301 1.ADJUST HOOD SUB-ASSEMBLY

a.
B337414

Adjust the hood position.

i.

Loosen the 4 hinge bolts on the hood and adjust the hood position.


ii.

Move the hood and adjust the clearance between the hood and front fender.


iii.

Tighten the 4 hinge bolts on the hood after the adjustment.

Torque:
13 N*m (133 kgf*cm, 9.6 ft.*lbf)



b.
B337415

Adjust the cushion rubbers so that the hood and fender are aligned.

HINT:

Raise or lower the front end of the hood by turning the cushion rubber.



c.
B337416

Adjust the hood lock.

i.

Loosen the 3 bolts.


ii.

Adjust the hood lock position so that the striker can enter it smoothly.


iii.

Tighten the 3 bolts after the adjustment.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)