Home › Brake › BRAKE (FRONT) › FRONT BRAKE(for 16 inch Front Brake)
RM3090E _54 Brake _008769 BRAKE (FRONT) _0049552 FRONT BRAKE(for 16 inch Front Brake) A

BRAKE (FRONT)  FRONT BRAKE(for 16 inch Front Brake)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 47313A 3.DISCONNECT FRONT FLEXIBLE HOSE

a.
C127057

Remove the union bolt and gasket.


b.

Disconnect the flexible hose from the disc brake cylinder.


Hide 47750 4.REMOVE DISC BRAKE CYLINDER ASSEMBLY LH

a.
C265921
2.65,2.296 2.813,2.448 0.163,0.152 10 *a 2.535,3.05 2.686,3.200 0.152,0.150 10 *b 2.329,2.533 2.516,2.39 2.516,2.39 2.638,2.39 false 1.872,2.655 2.411,3.138 2.411,3.138 2.521,3.138 false
*a Hold
*b Turn


Hold the front disc brake cylinder slide pin and remove the 2 bolts and disc brake cylinder.


Hide 04465 5.REMOVE FRONT DISC BRAKE PAD

a.

Remove the 2 disc brake pads.


Hide 04945 6.REMOVE FRONT ANTI-SQUEAL SHIM KIT

a.

Remove the 2 No. 1 anti-squeal shims and 2 No. 2 anti-squeal shims from each pad.


Hide 7.REMOVE NO. 1 PAD WEAR INDICATOR PLATE

a.

Remove the 2 pad wear indicator plates from the pads.


Hide 8.REMOVE NO. 1 FRONT DISC BRAKE PAD SUPPORT PLATE

a.
C265923
3.01,0.092 3.162,0.239 0.152,0.147 10 *1 2.961,1.833 3.110,1.976 0.149,0.143 10 *1 2.909,0.69 3.068,0.838 0.159,0.148 10 *2 3.009,1.265 3.167,1.411 0.158,0.146 10 *2 2.453,0.269 2.801,0.178 2.801,0.178 2.996,0.178 false 1.965,0.553 2.749,0.775 2.749,0.775 2.895,0.775 false 2.575,1.497 2.836,1.345 2.836,1.345 2.999,1.345 false 2.254,1.714 2.794,1.914 2.794,1.914 2.953,1.914 false
*1 No. 1 Front Disc Brake Pad Support Plate
*2 No. 2 Front Disc Brake Pad Support Plate


Remove the 2 No. 1 front disc brake pad support plates from the disc brake cylinder mounting.


Hide 9.REMOVE NO. 2 FRONT DISC BRAKE PAD SUPPORT PLATE

a.

Remove the 2 No. 2 front disc brake pad support plates from the disc brake cylinder mounting.


Hide 47722 10.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING LH

a.
C127059

Remove the 2 bolts and cylinder mounting.


Hide 47715A 11.REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN

a.
C127070
0.56,0.12 0.716,0.259 0.156,0.139 10 *1 0.455,1.253 0.612,1.397 0.157,0.144 10 *2 1.079,0.196 0.748,0.196 false 0.89,1.335 0.647,1.335 false
*1 Front Disc Brake Cylinder Slide Pin
*2 No. 2 Front Disc Brake Cylinder Slide Pin


Remove the front disc brake cylinder slide pin from the front disc brake cylinder mounting.


Hide 47715D 12.REMOVE NO. 2 FRONT DISC BRAKE CYLINDER SLIDE PIN

a.

Remove the No. 2 front disc brake cylinder slide pin from the front disc brake mounting.


Hide 47769 13.REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSH

a.
C127071
2.292,1.479 2.427,0.802 2.427,0.802 2.688,0.802 false 2.719,0.719 2.906,0.885 0.188,0.167 10 *a
*a Protective Tape


Using a screwdriver, remove the front disc brake cylinder slide bush from the No. 2 front disc brake cylinder slide pin.

HINT:

Tape the screwdriver tip before use.


NOTICE:

Be careful not to damage the pin.



Hide 14.REMOVE FRONT DISC BRAKE BUSH DUST BOOT

a.
C127072

Remove the 2 boots from the mounting.


Hide 43512 15.REMOVE FRONT DISC

a.
C127063
2.417,0.091 2.569,0.240 0.152,0.149 10 *a 1.761,1.049 1.761,0.177 1.761,0.177 2.395,0.177 false 1.782,1.164 1.963,1.164 1.963,1.164 1.963,0.177 false
*a Matchmark


Put matchmarks on the disc and axle hub.


b.

Remove the disc.