Home › Brake › BRAKE (FRONT) › FRONT BRAKE(for 17 inch Front Disc Brake)
RM3090E _54 Brake _008769 BRAKE (FRONT) _0049556 FRONT BRAKE(for 17 inch Front Disc Brake) A

BRAKE (FRONT)  FRONT BRAKE(for 17 inch Front Disc Brake)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 47313A 3.DISCONNECT FRONT FLEXIBLE HOSE

a.
C193673

Remove the union bolt and gasket.


b.

Disconnect the flexible hose from the brake cylinder.


Hide 47750 4.REMOVE DISC BRAKE CYLINDER ASSEMBLY LH

a.
C279249
2.594,2.25 2.792,2.115 2.792,2.115 2.979,2.115 false 1.979,2.104 2.396,3.042 2.396,3.042 2.531,3.042 false 3.01,2.042 3.219,2.24 0.208,0.198 10 *a 2.573,2.969 2.792,3.167 0.219,0.198 10 *b
*a Hold
*b Turn


Hold the front disc brake cylinder slide pin and remove the 2 bolts and disc brake cylinder assembly.


Hide 04465 5.REMOVE FRONT DISC BRAKE PAD

C193676

a.

Remove the 2 anti-squeal springs from the front disc brake pads.


b.

Remove the 2 brake pads from the front disc brake cylinder mounting.


Hide 04945 6.REMOVE FRONT ANTI-SQUEAL SHIM KIT

a.

Remove the No. 1 anti-squeal shim and No. 2 anti-squeal shim from each front disc brake pad.


Hide 7.REMOVE NO. 1 PAD WEAR INDICATOR PLATE

a.

Remove the 2 pad wear indicator plates from the front disc brake pads.


Hide 8.REMOVE NO. 1 FRONT DISC BRAKE PAD SUPPORT PLATE

a.
C279251
2.521,0.333 2.771,0.26 2.771,0.26 2.896,0.26 false 1.979,0.563 2.854,0.802 2.854,0.802 2.99,0.802 false 2.594,1.5 2.896,1.281 2.896,1.281 3.031,1.281 false 2.24,1.719 2.885,1.927 2.885,1.927 3.042,1.927 false 2.958,0.177 3.156,0.354 0.198,0.177 10 *1 3.042,0.719 3.219,0.885 0.177,0.167 10 *2 3.083,1.854 3.292,2.063 0.208,0.208 10 *3 3.073,1.208 3.292,1.385 0.219,0.177 10 *4
*1 No. 1 Front Disc Brake Pad Support Plate
*2 No. 2 Front Disc Brake Pad Support Plate
*3 No. 3 Front Disc Brake Pad Support Plate
*4 No. 4 Front Disc Brake Pad Support Plate


Remove the No. 1 front disc brake pad support plate from the front disc brake cylinder mounting.


Hide 9.REMOVE NO. 2 FRONT DISC BRAKE PAD SUPPORT PLATE

a.

Remove the No. 2 front disc brake pad support plate from the front disc brake cylinder mounting.


Hide 10.REMOVE NO. 3 FRONT DISC BRAKE PAD SUPPORT PLATE

a.

Remove the No. 3 front disc brake pad support plate from the front disc brake cylinder mounting.


Hide 11.REMOVE NO. 4 FRONT DISC BRAKE PAD SUPPORT PLATE

a.

Remove the No. 4 front disc brake pad support plate from the front disc brake cylinder mounting.


Hide 47722 12.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING LH

a.
C279252

Remove the 2 bolts and front disc brake cylinder mounting.


Hide 47715A 13.REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN

a.
C127070
0.56,0.12 0.716,0.259 0.156,0.139 10 *1 0.455,1.253 0.612,1.397 0.157,0.144 10 *2 1.079,0.196 0.748,0.196 false 0.89,1.335 0.647,1.335 false
*1 Front Disc Brake Cylinder Slide Pin
*2 No. 2 Front Disc Brake Cylinder Slide Pin


Remove the front disc brake cylinder slide pin from the front disc brake cylinder mounting.


Hide 47715D 14.REMOVE NO. 2 FRONT DISC BRAKE CYLINDER SLIDE PIN

a.

Remove the No. 2 front disc brake cylinder slide pin from the front disc brake cylinder mounting.


Hide 47769 15.REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSH

a.
C127071
2.292,1.479 2.427,0.802 2.427,0.802 2.688,0.802 false 2.729,0.719 2.917,0.885 0.188,0.167 10 *a
*a Protective Tape


Using a screwdriver, remove the front disc brake cylinder slide bush from the No. 2 front disc brake cylinder slide pin.

HINT:

Tape the screwdriver tip before use.


NOTICE:

Be careful not to damage the pin.



Hide 16.REMOVE FRONT DISC BRAKE BUSH DUST BOOT

a.
C127072

Remove the 2 front disc brake bush dust boots from the front disc brake cylinder mounting.


Hide 43512 17.REMOVE FRONT DISC

a.
C278598
2.01,1.052 2.01,0.167 2.01,0.167 2.74,0.167 false 2.031,1.094 2.375,1.094 2.375,1.094 2.375,0.177 false 2.813,0.073 3.01,0.281 0.198,0.208 10 *a
*a Matchmark


Put matchmarks on the disc and axle hub.


b.

Remove the disc.