Home › Brake › BRAKE (FRONT) › FRONT BRAKE(for 17 inch Front Disc Brake)
RM3090E _54 Brake _008769 BRAKE (FRONT) _0049556 FRONT BRAKE(for 17 inch Front Disc Brake) A

BRAKE (FRONT)  FRONT BRAKE(for 17 inch Front Disc Brake)  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 47547B 1.TEMPORARILY INSTALL FRONT DISC BRAKE BLEEDER PLUG

a.

Temporarily install the front disc brake bleeder plug to the disc brake cylinder.

HINT:

The front disc brake bleeder plug will be tightened to a torque specification in the "Bleed Brake Line" procedures.



Hide 31478B 2.INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP

Hide 3.INSTALL PISTON SEAL

a.
C278604
0.698,2.948 0.896,3.104 0.198,0.156 10 *1
*1 Lithium soap base glycol grease


Apply a light coat of lithium soap base glycol grease to the entire inner and outer circumference of a new piston seal.


b.

Install the piston seal to the disc brake cylinder.

NOTICE:

Securely install the piston seal into the groove of the disc brake cylinder.



Hide 47731 4.INSTALL FRONT DISC BRAKE PISTON

a.
C278605
0.688,2.948 0.896,3.115 0.208,0.167 10 *1
*1 Lithium soap base glycol grease


Apply a light coat of lithium soap base glycol grease to the inner and outer circumference of a new cylinder boot, as well as the entire circumference of the top and bottom of the outer edge as shown in the illustration.


b.

Apply a light coat of lithium soap base glycol grease to the entire outer circumference of the front disc brake piston where it contacts the cylinder boot and front disc brake cylinder.


c.

Install the cylinder boot to the front disc brake piston.


Hide 5.INSTALL CYLINDER BOOT

a.
C278606
1.51,0.49 1.385,0.24 1.385,0.24 0.844,0.24 false 1.313,0.802 0.99,0.854 0.99,0.854 0.729,0.854 false 0.646,0.177 0.792,0.365 0.146,0.188 10 *1 0.521,0.781 0.688,0.958 0.167,0.177 10 *2
*1 Cylinder Boot
*2 Piston


Install the front disc brake piston to the front disc brake cylinder.

NOTICE:

Do not forcibly install the piston to the disc brake cylinder.



b.

Install the cylinder boot to the disc brake cylinder.

NOTICE:

Securely install the cylinder boot into the groove of the disc brake cylinder.