Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for LHD)
RM3090E _54 Brake _008768 BRAKE SYSTEM (OTHER) _0049559 BRAKE MASTER CYLINDER(for LHD) G

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for LHD)  INSPECTION  


PROCEDURE

Hide 1.INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD

a.

Apply chalk to the tip of the accessory tool.

HINT:

An accessory tool is included with a new brake master cylinder sub-assembly.



b.
F048138
0.479,1.125 1.615,1.813 1.615,1.813 1.927,1.813 false 2.292,0.958 2.292,0.531 2.292,0.531 2.417,0.531 false 1.979,1.729 2.167,1.896 0.188,0.167 10 *1 2.5,0.448 2.719,0.635 0.219,0.188 10 *a
*1 Accessory Tool
*a Apply Chalk


Place the accessory tool on the brake booster assembly.


c.

Measure the clearance between the brake booster push rod and accessory tool.

Standard clearance:

0 mm (0 in.)


HINT:

Adjust the clearance in the following cases:

·

If there is a clearance between the accessory tool and the shell of the brake booster (floating accessory tool), the push rod is protruding too far.


·

If the chalk does not stick on the tip of the brake booster push rod, the push rod protrusion is insufficient.




d.
C128539
2.063,1.677 1.406,1.156 false 2.094,1.635 2.448,1.823 0.354,0.188 10 SST

If the clearance is not within the standard, adjust the length by holding the rod using SST and turning the tip of the rod using a 7 mm socket driver.

SST
09737-00020  

NOTICE:

Check the push rod clearance again after adjusting.