Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for RHD)
RM3090E _54 Brake _008768 BRAKE SYSTEM (OTHER) _0049560 BRAKE MASTER CYLINDER(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure the tip of the master cylinder points downward when handling the master cylinder.

·

Make sure foreign matter does not adhere to the piston of the master cylinder. If foreign matter adheres, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.



PROCEDURE

Hide 1.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 47201 2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

C127055
0.604,0.792 0.75,0.948 0.146,0.156 10 A 1.24,1.635 1.385,1.792 0.146,0.156 10 C 1.448,0.719 1.594,0.875 0.146,0.156 10 B 1.708,1.594 1.854,1.75 0.146,0.156 10 C

a.

Release the vacuum pressure in the brake booster as follows.

i.

Stop the engine.


ii.

Depress the brake pedal several times.



b.

for Manual Transaxle:

Disconnect the clutch reservoir tube labeled A from the brake master cylinder.


c.

Disconnect the brake fluid level warning switch connector labeled B.


d.

Using a union nut wrench, disconnect the 2 brake lines labeled C from the brake master cylinder.


e.

Remove the 2 nuts.


f.
C127056

Pull out the master cylinder from the brake booster.

NOTICE:
·

The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure the tip of the master cylinder points downward when handling the master cylinder.

·

Make sure foreign matter does not adhere to the piston of the master cylinder. If foreign matter adheres, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.




g.

Remove the O-ring from the brake master cylinder.