Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for RHD)
RM3090E _54 Brake _008768 BRAKE SYSTEM (OTHER) _0049560 BRAKE MASTER CYLINDER(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for RHD)  DISASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
·

The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure the tip of the master cylinder points downward when handling the master cylinder.

·

Make sure foreign matter does not adhere to the piston of the master cylinder. If foreign matter adheres, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.



PROCEDURE

Hide 47201C 1.REMOVE BRAKE MASTER CYLINDER RING PIN

a.

Mount the brake master cylinder sub-assembly in a vise.

NOTICE:

Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.



b.

Using a pin punch and hammer, remove the pin from the brake master cylinder reservoir.


Hide 47202 2.REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

a.

Remove the brake master cylinder reservoir from the brake master cylinder sub-assembly.


Hide 47255 3.REMOVE MASTER CYLINDER RESERVOIR GROMMET

a.

Remove the 2 master cylinder reservoir grommets from the brake master cylinder sub-assembly.


Hide 47287 4.REMOVE BRAKE FLUID INFORMATION LABEL

Hide 47230 5.REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY

a.

Remove the brake master cylinder reservoir filler cap assembly from the brake master cylinder reservoir.


Hide 47299 6.REMOVE BRAKE MASTER CYLINDER RESERVOIR STRAINER

a.

Remove the brake master cylinder reservoir strainer from the brake master cylinder reservoir.