Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for RHD)
RM3090E _54 Brake _008768 BRAKE SYSTEM (OTHER) _0049560 BRAKE MASTER CYLINDER(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for RHD)  REASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
·

The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure the tip of the master cylinder points downward when handling the master cylinder.

·

Make sure foreign matter does not adhere to the piston of the master cylinder. If foreign matter adheres, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.



PROCEDURE

Hide 47299 1.INSTALL BRAKE MASTER CYLINDER RESERVOIR STRAINER

a.

Install the brake master cylinder reservoir strainer to the brake master cylinder reservoir.


Hide 47230 2.INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY

a.

Install the brake master cylinder reservoir filler cap assembly to the brake master cylinder reservoir.


Hide 47287 3.INSTALL BRAKE FLUID INFORMATION LABEL

Hide 47255 4.INSTALL MASTER CYLINDER RESERVOIR GROMMET

a.
C278587
0.792,4.156 1.104,4.354 0.313,0.198 10 *1
*1 Lithium soap base glycol grease


Apply a light coat of lithium soap base glycol grease to 2 new master cylinder reservoir grommets, and then install them to the brake master cylinder reservoir.


Hide 47202 5.INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

a.

Install the brake master cylinder reservoir to the brake master cylinder body.


Hide 47201C 6.INSTALL BRAKE MASTER CYLINDER RING PIN

a.

Using a pin punch and hammer, install a pin to the brake master cylinder reservoir.