Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER(for LHD)
RM3090E _54 Brake _008768 BRAKE SYSTEM (OTHER) _0049561 BRAKE BOOSTER(for LHD) G

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(for LHD)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 44610 1.CHECK BRAKE BOOSTER ASSEMBLY

C111618
0.281,0.115 0.615,0.333 0.333,0.219 10 *a 1.781,0.104 2.094,0.333 0.313,0.229 10 *b 0.646,1.896 0.833,2.125 0.188,0.229 10 *c 1,1.813 1.229,2.031 0.229,0.219 10 *d 1.271,1.635 1.458,1.854 0.188,0.219 10 *e
*a CORRECT
*b INCORRECT
*c 1st
*d 2nd
*e 3rd


a.

Airtightness check

i.

Start the engine and stop it after 1 or 2 minutes. Slowly depress the brake pedal several times.


ii.

Make sure the booster is airtight. Check that the distance the pedal can be depressed decreases gradually in correlation with each subsequent press of the pedal.

If the pedal is not as specified, check the check valve.

If the check valve is normal, replace the booster.


iii.

Start the engine. Depress and hold down the pedal, and stop the engine.


iv.

Make sure the booster is airtight. Hold the pedal for 30 seconds and check that there is no change in the pedal reserve distance.

If the pedal is not as specified, check the check valve.

If the check valve is normal, replace the booster.



b.

Operation check

i.

Stop the engine.


ii.
C128542

Depress the pedal several times and check that there is no change in the pedal reserve distance.


iii.
C128543

Depress and hold down the pedal, and start the engine. Check that the pedal can only be depressed slightly.

If the pedal is not as specified, check the check valve.

If the check valve is normal, replace the booster.