Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP(for 3ZR-FAE) › 2012.12–2016.08
RM3090E _54 Brake _008768 BRAKE SYSTEM (OTHER) _0049564 VACUUM PUMP(for 3ZR-FAE) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 3ZR-FAE)  REASSEMBLY  


PROCEDURE

Hide 29331A 1.INSTALL VACUUM PUMP VANE

a.

Apply engine oil to the vacuum pump vane and vacuum pump vane caps and install the caps to the vane.


b.
C278623

Apply engine oil to the vacuum pump vane with vacuum pump vane caps and install it to the vacuum pump housing.

NOTICE:

When reusing the vacuum pump vane and 2 vacuum pump vane caps, install them in the same position and orientation as when they were removed.



Hide 29314A 2.INSTALL END COVER

a.
C169343C02
0.783,4.12 0.938,4.267 0.155,0.147 10 *1 0.859,3.446 0.859,4.106 false
*1 No. 1 O-ring


Coat a new No. 1 O-ring with engine oil and install it to the vacuum pump.

NOTICE:
·

Wipe off any oil on the vacuum pump end cover installation surface and end cover.

·

Check that no foreign matter is on the O-ring or inside the vacuum pump housing.




b.
C169335

Using a T25 "TORX" socket wrench, install the end cover with 5 new screws.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:
·

Hold the pump so that the pump installation surface, fitting parts and oil pump will not be damaged.

·

As the housing deforms when force is applied, do not clamp the housing with a tool such as a vise.




c.
C169333

Turn the coupling clockwise as shown in the illustration and check that the coupling is not stuck or that there is no abnormal resistance.