Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR(w/o VSC) › 2012.12–2015.10
RM3090E _54 Brake _008767 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0049568 BRAKE ACTUATOR(w/o VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR(w/o VSC)  REASSEMBLY  


PROCEDURE

Hide 44546A 1.INSTALL BRAKE ACTUATOR BOLT CUSHION

a.

Install the 3 brake actuator bolt cushions to the brake actuator bracket.


Hide 2.INSTALL BRAKE ACTUATOR CASE COLLAR

a.

Install the 3 brake actuator case collars to the 3 brake actuator bolt cushions.

NOTICE:

Make sure the collars are in full contact with the cushions.



Hide 44591 3.INSTALL NO. 1 BRAKE ACTUATOR BRACKET

a.
C274694E01
1.76,1.354 1.917,1.552 0.156,0.198 10 C 1.271,1.583 1.427,1.781 0.156,0.198 10 B 0.615,1.271 0.771,1.469 0.156,0.198 10 A

Install the brake actuator bracket to the brake actuator with the 3 bolts. Tighten the 3 bolts uniformly in alphabetical order.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:
·

Do not remove the hole plugs of a new brake actuator before connecting the 6 brake lines because the brake actuator is filled with brake fluid.

·

Do not hold the actuator by the connector.

·

If the actuator is dropped, replace it.