Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND DECELERATION SENSOR(for 4WD/AWD without VSC) › 2012.12–2015.10
RM3090E _54 Brake _008767 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0049571 YAW RATE AND DECELERATION SENSOR(for 4WD/AWD without VSC) G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  YAW RATE AND DECELERATION SENSOR(for 4WD/AWD without VSC)  INSPECTION  


PROCEDURE

Hide 89441A 1.CHECK DECELERATION SENSOR

a.

Check the deceleration sensor.

Under any of the following conditions, replace the sensor with a new one.

·

The surface of the sensor is cracked, dented, or chipped off.

·

The connector or wire harness is scratched, cracked, or damaged.

·

The sensor has been dropped.



Hide 89441A 2.INSPECT DECELERATION SENSOR

a.
C108887C01
2.115,0.938 1.49,0.75 1.49,0.75 1.49,0.969 false 2.281,0.927 2.323,0.417 2.323,0.417 2.042,0.417 false 2.531,0.958 2.646,0.531 2.646,0.531 2.771,0.531 false 1.24,0.323 1.917,0.552 0.677,0.229 10 2 (GGND) 2.813,0.469 3.344,0.75 0.531,0.281 10 3 (GL1) 1.26,1 1.833,1.177 0.573,0.177 10 1 (VGS) 2.448,2.438 2.667,2.646 0.219,0.208 10 *a 2.396,3.427 2.594,3.635 0.198,0.208 10 *b 1.052,4.208 1.25,4.406 0.198,0.198 10 *c
*a Front
*b Forward
*c Rearward


Connect 3 dry cell batteries of 1.5 V in series (approximately 4.5 V total).


b.

Connect the batteries' positive (+) lead to terminal 1 (VGS) and the negative (-) lead to terminal 2 (GGND).

NOTICE:

Do not apply 6 V or higher to terminals 1 (VGS) and 2 (GGND).



c.

Connect the voltmeter's positive (+) lead to the negative (-) lead of the batteries, and the negative (-) lead to terminal 3 (GL1).


d.

Check the output voltage of terminal 3 (GL1) when the sensor is tilted forward and rearward.

Standard Voltage:
Tester Connection Sensor Position Specified Condition
3 (GL1) - Battery negative (-) lead Horizontal Approx. 2.25 V
3 (GL1) - Battery negative (-) lead Tilted forward Approx. 0.45 to 2.25 V
3 (GL1) - Battery negative (-) lead Tilted rearward Approx. 2.25 to 4.05 V


If the result is not as specified, replace the deceleration sensor.

HINT:
·

If voltage drops, the sensor should be replaced with a new one.

·

When replacing the sensor, it should not be placed upside down.