Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › DOWNHILL ASSIST CONTROL SWITCH
RM3090E _54 Brake _008767 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0049574 DOWNHILL ASSIST CONTROL SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  DOWNHILL ASSIST CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 84988H 1.CHECK DOWNHILL ASSIST CONTROL SWITCH

a.
C128533
2.667,1.354 3.24,1.073 false 2.656,1.427 3.229,1.323 false 2.656,1.5 3.24,1.604 false 2.656,1.583 3.229,1.875 false 3.281,0.948 3.396,1.115 0.115,0.167 10 4 3.281,1.229 3.396,1.396 0.115,0.167 10 3 3.281,1.51 3.396,1.677 0.115,0.167 10 2 3.281,1.802 3.396,1.969 0.115,0.167 10 1 0.146,0.177 0.396,0.375 0.25,0.198 10 *a 0.323,2.229 0.51,2.406 0.188,0.177 10 *c 1.177,2.219 1.365,2.396 0.188,0.177 10 *b
*a Component without harness connected (Downhill Assist Control Switch)
*b Pushed
*c Not pushed


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 4 Not pushed 10 kΩ or higher
1 - 4 Pushed Below 25 Ω


If the result is not as specified, replace the switch.


b.

Check the illumination operation.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 3
Battery negative (-) → Terminal 2
Bulb illuminates


If the result is not as specified, replace the switch.