Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR(w/ VSC) › 2012.12–2015.10
RM3090E _54 Brake _008767 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0049575 BRAKE ACTUATOR(w/ VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR(w/ VSC)  REASSEMBLY  


PROCEDURE

Hide 44546A 1.INSTALL BRAKE ACTUATOR BOLT CUSHION

a.

Install the 4 brake actuator bolt cushions to the brake actuator bracket.


Hide 2.INSTALL BRAKE ACTUATOR CASE COLLAR

a.

Install the 4 brake actuator case collars to the brake actuator bolt cushions.

NOTICE:

Make sure the collars are in full contact with the cushions.



Hide 3.INSTALL BRAKE ACTUATOR BRACKET

a.
C191858E01
1.28,0.83 1.403,0.979 0.123,0.149 10 A 2.631,1.034 2.754,1.183 0.123,0.149 10 B 1.199,1.322 1.322,1.471 0.123,0.149 10 C 2.381,1.448 2.504,1.597 0.123,0.149 10 D

Install the brake actuator bracket to the brake actuator with the 4 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:
·

Tighten the 4 bolts uniformly in alphabetical order.

·

If the actuator is dropped, replace it.