Home › Engine / Hybrid System › 3ZR-FAE STARTING › STARTER › 2012.12–2016.08
RM3090E _51 Engine / Hybrid System _008393 3ZR-FAE STARTING _0049596 STARTER A

3ZR-FAE STARTING  STARTER  DISASSEMBLY  


PROCEDURE

Hide 28150 1.REMOVE MAGNET STARTER SWITCH ASSEMBLY

A156357

a.

Remove the nut and disconnect the lead wire from terminal C.


b.
A156358

Remove the 2 nuts from the starter drive housing assembly while holding the magnet starter switch assembly.


c.
A156359
1.281,0.646 1.438,0.156 false 0.906,0.792 0.51,0.208 false 1.458,0.073 1.625,0.24 0.167,0.167 10 *1 0.302,0.135 0.469,0.302 0.167,0.167 10 *2
*1 Hook
*2 Drive Lever


Pull the magnet starter switch assembly and while lifting the front part of the magnet starter switch assembly, release the plunger hook from the drive lever and remove the magnet starter switch assembly.


Hide 28120 2.REMOVE STARTER YOKE ASSEMBLY

a.
A211487

Remove the 2 through bolts and pull out the starter commutator end frame assembly together with the starter armature assembly.


Hide 28140 3.REMOVE STARTER BRUSH HOLDER ASSEMBLY

a.
A156361

Remove the 2 screws and, while holding down the lead wire, remove the starter commutator end frame assembly.


b.
A064784

Remove the starter brush holder assembly.

i.

for Starter Yoke Side:

Using a screwdriver, pry the springs and disconnect the 2 brushes from the starter brush holder assembly.


ii.
A211481

for Brush Holder Side:

Using a screwdriver, pry the end of the spring away from each brush and pull out the 2 brushes from the starter brush holder assembly so that they are held in place by the springs.


iii.

Remove the starter brush holder assembly.



Hide 28160 4.REMOVE STARTER ARMATURE ASSEMBLY

a.

Remove the starter armature assembly from the starter yoke assembly.


Hide 28021 5.REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

A156362

a.

Remove the drive lever and the starter center bearing clutch sub-assembly with shock absorber from the starter drive housing assembly.


b.
A033589

Using a screwdriver, tap in the stop collar toward the starter center bearing clutch sub-assembly.


c.
A033590

Using a screwdriver, pry off the snap ring.


d.

Remove the stop collar and starter center bearing clutch sub-assembly from the planetary shaft.