Home › Power Source / Network › 2AD-FHV BATTERY / CHARGING › BATTERY CURRENT SENSOR
RM3090E _57 Power Source / Network _008778 2AD-FHV BATTERY / CHARGING _0049602 BATTERY CURRENT SENSOR A

2AD-FHV BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 28850 2.REMOVE BATTERY CURRENT SENSOR ASSEMBLY

a.

Loosen the nut and remove the negative (-) battery terminal from the battery.


b.
A190539

Remove the nut.


c.

Remove the battery current sensor assembly and No. 3 engine wire from the negative (-) battery terminal.


d.
A192586C02
2.656,1.104 2.313,1.104 false 2.75,1.01 2.927,1.198 0.177,0.188 10 *1
*1 No. 3 Engine Wire


Disconnect the connector from the battery current sensor assembly.


e.

Remove the battery current sensor assembly from the No. 3 engine wire.