Home › Engine / Hybrid System › STOP AND START › VACUUM SENSOR ASSEMBLY
RM3090E _51 Engine / Hybrid System _009049 STOP AND START _0049619 VACUUM SENSOR ASSEMBLY A

STOP AND START  VACUUM SENSOR ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 44696 1.INSTALL VACUUM SENSOR GROMMET

a.

Install a new vacuum sensor grommet to the brake booster assembly.


Hide 89420H 2.INSTALL VACUUM SENSOR ASSEMBLY

a.
A273344C01
0.052,0.073 0.365,0.229 0.313,0.156 10 *A 0.104,2.49 0.417,2.646 0.313,0.156 10 *B 1.448,1.719 1.76,1.875 0.313,0.156 10 *a 2.188,3.74 2.5,3.896 0.313,0.156 10 *b
*A for LHD
*B for RHD
*a Approximately 10°
*b Approximately 25°


Install the vacuum sensor assembly to the brake booster assembly so that the vacuum sensor assembly is angled as shown in the illustration.


b.

Connect the connector to the vacuum sensor assembly.


Hide 47028 3.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY (for LHD)

Hide 47028 4.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY (for RHD)