Home › Engine / Hybrid System › STOP AND START › STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY › 2012.12–2015.04
RM3090E _51 Engine / Hybrid System _009049 STOP AND START _0049621 STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY G

STOP AND START  STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY  INSPECTION  


PROCEDURE

Hide 84970 1.INSPECT STOP AND START SYSTEM CANCEL SWITCH

a.
A273347C01
2.479,1.99 2.302,1.99 2.302,1.99 1.99,1.448 true 0.979,1.969 1.198,1.969 1.198,1.969 1.479,1.438 true 0.083,0.063 0.396,0.219 0.313,0.156 10 false *a 2.583,1.906 3.042,2.104 0.458,0.198 10 false ECU 0.76,1.885 1.083,2.083 0.323,0.198 10 false E
*a Component without harness connected
(Stop and Start System Cancel Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
2 (ECU) - 4 (E) Pushed Below 1 Ω
Not Pushed 10 kΩ or higher


If the result is not as specified, replace the stop and start system cancel switch.


b.
A273347C02
0.74,1.958 0.958,1.958 0.958,1.958 1.24,1.448 true 2.688,1.948 2.448,1.948 2.448,1.948 2.26,1.448 true 0.073,0.052 0.385,0.208 0.313,0.156 10 false *a 2.823,1.865 3.25,2.073 0.427,0.208 10 false ILL+ 0.375,1.885 0.802,2.094 0.427,0.208 10 false ILL-
*a Component without harness connected
(Stop and Start System Cancel Switch)


Apply battery voltage between the terminals of the switch, and check the illumination condition of the stop and start system cancel switch.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 1 (ILL+)
Battery negative (-) → 5 (ILL-)
Illuminates


If the result is not as specified, replace the stop and start system cancel switch.