Home › Drivetrain › U660F AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP
RM3090E _52 Drivetrain _008436 U660F AUTOMATIC TRANSMISSION / TRANSAXLE _0047095 OIL PUMP G

U660F AUTOMATIC TRANSMISSION / TRANSAXLE  OIL PUMP  INSPECTION  


PROCEDURE

Hide 1.INSPECT OIL PUMP ASSEMBLY

a.
C138512

Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

NOTICE:

Be careful not to damage the oil seal lip.



Hide 35035 2.INSPECT CLEARANCE OF FRONT OIL PUMP BODY AND GEAR SUB-ASSEMBLY

a.
C138509

Inspect the body clearance.

i.

Push the driven gear to one side of the front oil pump body.


ii.

Using a feeler gauge, measure the front oil pump body clearance.

Standard clearance:

0.08 to 0.15 mm (0.00315 to 0.00590 in.)


Maximum clearance:

0.15 mm (0.00590 in.)


If the clearance is more than the maximum, replace the front oil pump drive gear, front oil pump driven gear or front oil pump body sub-assembly.



b.
C138511

Inspect the side clearance.

If the clearance is more than the maximum, replace the front oil pump body sub-assembly.

i.

Using a straightedge and feeler gauge, measure the side clearance of both gears.

Standard side clearance:

0.035 to 0.05 mm (0.00138 to 0.00196 in.)


Maximum side clearance:

0.05 mm (0.00197 in.)

Drive Gear Thickness
Mark Thickness
1 11.547 to 11.555 mm (0.45461 to 0.45492 in.)
2 11.555 to 11.563 mm (0.45493 to 0.45523 in.)
3 11.564 to 11.571 mm (0.45528to 0.45555 in.)
4 11.572 to 11.579 mm (0.45559 to 0.45586 in.)
5 11.580 to 11.587 mm (0.45591 to 0.45618 in.)

Driven Gear Thickness
Mark Thickness
1 11.547 to 11.555 mm (0.45461 to 0.45492 in.)
2 11.555 to 11.563 mm (0.45493 to 0.45523 in.)
3 11.564 to 11.571 mm (0.45528to 0.45555 in.)
4 11.572 to 11.579 mm (0.45559 to 0.45586 in.)
5 11.580 to 11.587 mm (0.45591 to 0.45618 in.)


If the clearance is more than the maximum, replace the front oil pump body sub-assembly.



Hide 35035 3.INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY

a.
C138514

Using a caliper gauge, measure the inside diameter of the front oil pump body bushing.

Standard inside diameter:

43.113 to 43.138 mm (1.6974 to 1.6983 in.)


Maximum inside diameter:

43.188 mm (1.7003 in.)


If the inside diameter is more than the maximum, replace the front oil pump body sub-assembly.


Hide 35370 4.INSPECT STATOR SHAFT ASSEMBLY

a.
C138513

Using a caliper gauge, measure the inside diameter of the stator shaft bushing.

Standard inside diameter:

22.500 to 22.526 mm (0.88583 to 0.88684 in.)


Maximum inside diameter:

22.570 mm (0.8886 in.)


If the inside diameter is more than the maximum, replace the stator shaft assembly.