28255
1.INSTALL PLANETARY GEAR
Apply high-temperature grease to the planetary gears of the planetary shaft.
|
High-temperature Grease |
Install the 3 planetary gears.
28177
2.INSTALL STARTER ARMATURE PLATE
| *1 | Cutout |
| *2 | Protrusion |
Insert the starter armature plate to the starter center bearing clutch sub-assembly.
Check that the cutout of the starter armature plate fits over the protrusion of the starter center bearing clutch sub-assembly.
28160
3.INSTALL STARTER ARMATURE ASSEMBLY
Install the starter armature assembly to the starter center bearing clutch sub-assembly.
28120
4.INSTALL STARTER YOKE ASSEMBLY
| *1 | Cutout |
| *2 | Protrusion |
Align the protrusion of the starter center bearing clutch sub-assembly with the cutout of the starter yoke assembly, and install the starter yoke assembly.
28130
5.INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY
Install the starter brush holder assembly.
Using a screwdriver, hold the brush spring back and connect the brush into the starter brush holder assembly.
Connect the 4 brushes.
| *1 | Groove |
| *2 | Rubber |
Align the starter commutator end frame assembly rubber with the groove of the starter yoke assembly.
Install the starter commutator end frame assembly with the 2 screws.
28110
6.INSTALL STARTER DRIVE HOUSING ASSEMBLY
|
High-temperature Grease |
Apply high-temperature grease to the starter pinion drive lever.
Install the starter pinion drive lever to the starter center bearing clutch sub-assembly.
| *1 | Protrusion |
| *2 | Groove |
Align the protrusion of the starter center bearing clutch sub-assembly with the groove inside the starter drive housing assembly, and install the starter center bearing clutch sub-assembly to the starter drive housing assembly.
Using a T30 "TORX" socket wrench, install the starter drive housing assembly with the 2 through bolts.
28226A
7.INSTALL STARTER MAGNETIC SWITCH ASSEMBLY
Install the starter magnetic switch assembly with the 2 nuts.
Connect the lead wire to the starter magnetic switch assembly with the nut.