Home › Power Source / Network › 1AD-FTV BATTERY / CHARGING › GENERATOR › 2012.12–2015.10
RM3090E _57 Power Source / Network _008779 1AD-FTV BATTERY / CHARGING _0049700 GENERATOR G

1AD-FTV BATTERY / CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 27370 1.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

a.
A297148

Using a vernier caliper, measure the brush length.

Standard exposed length:

9.5 to 11.5 mm (0.374 to 0.453 in.)


Minimum exposed length:

4.5 mm (0.177 in.)


If the brush length is less than the minimum, replace the generator brush holder assembly.


Hide 27330 2.INSPECT GENERATOR ROTOR ASSEMBLY

a.

Check the resistance.

i.
A296802
0.667,1.146 0.292,0.792 0.292,0.792 0.781,1.104 true 0.115,0.708 0.427,0.865 0.313,0.156 10 *1
*1 Slip Ring


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Slip ring 20°C (68°F) 1.5 to 1.9 Ω


If the result is not as specified, replace the generator rotor assembly.


ii.
A296803
0.188,0.979 0.323,0.979 0.323,0.979 0.365,1.156 true 1.281,0.813 1.625,0.448 1.625,0.448 1.875,0.448 true 0.021,0.906 0.333,1.063 0.313,0.156 10 *1 1.906,0.365 2.219,0.521 0.313,0.156 10 *2
*1 Slip Ring
*2 Rotor Core


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Rotor core Always 10 MΩ or higher


If the result is not as specified, replace the generator rotor assembly.



b.
A196744

Check that the bearing is not rough or worn, and that it rotates smoothly.

If the result is not as specified, replace the generator rotor assembly.


c.

Check each slip ring.

i.

Check that the slip rings are not rough or scored.

If rough or scored, replace the generator rotor assembly.


ii.
A297149

Using a vernier caliper, measure the diameter of the slip rings.

Standard diameter:

14.2 to 14.8 mm (0.560 to 0.582 in.)


Minimum diameter:

14.0 mm (0.551 in.)


If the diameter is less than the minimum, replace the generator rotor assembly.



Hide 27415 3.INSPECT GENERATOR PULLEY WITH CLUTCH

a.
A196799
0.625,0.75 0.927,0.917 0.302,0.167 10 *a 2.719,0.75 3.042,0.917 0.323,0.167 10 *b
*a Free
*b Lock


Hold the center of the generator pulley with clutch, and confirm that the outer ring turns counterclockwise and does not turn clockwise.

If the result is not as specified, replace the generator pulley with clutch.