Home › Power Source / Network › 1AD-FTV BATTERY / CHARGING › BATTERY CURRENT SENSOR › 2012.12–2015.10
RM3090E _57 Power Source / Network _008779 1AD-FTV BATTERY / CHARGING _0049701 BATTERY CURRENT SENSOR A

1AD-FTV BATTERY / CHARGING  BATTERY CURRENT SENSOR  INSTALLATION  


PROCEDURE

Hide 28850 1.INSTALL GENERATOR CONTROL ECU ASSEMBLY (BATTERY CURRENT SENSOR)

a.

Install the negative (-) battery terminal to the battery and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


b.
A297155C01
1.25,0.25 1.417,0.25 1.417,0.25 1.719,0.615 true 2.823,0.281 2.656,0.281 2.656,0.281 2.49,0.615 true 2.865,0.208 3.177,0.365 0.313,0.156 10 *1 1.083,0.177 1.396,0.333 0.313,0.156 10 *2
*1 Nut A
*2 Nut B


Connect the generator control ECU assembly to the negative (-) battery terminal with nut A.

Torque:
7.6 N*m (77 kgf*cm, 67 in.*lbf)


c.

Connect the No. 3 engine wire to the generator control ECU assembly with nut B.

Torque:
7.6 N*m (77 kgf*cm, 67 in.*lbf)


d.

Connect the connector to the generator control ECU assembly.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION