Home › Engine / Hybrid System › 2AD-FTV ENGINE CONTROL › ECD SYSTEM(for CCo)
RM3090E _51 Engine / Hybrid System _008377 2AD-FTV ENGINE CONTROL _0049703 ECD SYSTEM(for CCo) U

2AD-FTV ENGINE CONTROL  ECD SYSTEM(for CCo)  FAIL-SAFE CHART  


FAIL-SAFE CHART


If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.

DTC No. Detection Item Fail-safe Operation Fail-safe Deactivation Condition
P007C Charge Air Cooler Temperature Sensor Circuit High The intake air temperature is fixed at a specified value. Pass condition detected
P007D Charge Air Cooler Temperature Sensor Circuit High The intake air temperature is fixed at a specified value. Pass condition detected
P0087 Fuel Rail/System Pressure - Too Low The engine power is reduced by 90%.* Ignition switch off
P0088 Fuel Rail/System Pressure - Too High The engine power is reduced by 90%.* Ignition switch off
P0093 Fuel System Leak Detected - Large Leak The engine power is reduced by 90%.* Ignition switch off
P0100 Mass or Volume Air Flow Circuit Malfunction The engine power is limited. Pass condition detected
P0101 Mass or Volume Air Flow Circuit The engine power is limited. Ignition switch off
P0107 Manifold Absolute Pressure/Barometric Pressure Circuit Low Input The turbo pressure is fixed at a specified value. Pass condition detected
P0108 Manifold Absolute Pressure/Barometric Pressure Circuit High Input The turbo pressure is fixed at a specified value. Pass condition detected
P0112 Intake Air Temperature Circuit Low Input The intake air temperature value is fixed. Pass condition detected
P0113 Intake Air Temperature Circuit High Input The intake air temperature value is fixed. Pass condition detected
P0115 Engine Coolant Temperature Circuit The engine coolant temperature sensor output is fixed at a specified value (the fixed value varies depending on conditions). Pass condition detected
P0117 Engine Coolant Temperature Circuit Low Input The engine coolant temperature sensor output is fixed at a specified value (the fixed value varies depending on conditions). Pass condition detected
P0118 Engine Coolant Temperature Circuit High Input The engine coolant temperature sensor output is fixed at a specified value (the fixed value varies depending on conditions). Pass condition detected
P0122 Throttle/Pedal Position Sensor/Switch "A" Circuit Low Input The engine power is limited. Ignition switch off
P0123 Throttle/Pedal Position Sensor/Switch "A" Circuit High Input The engine power is limited. Ignition switch off
P0168 Fuel Temperature Too High The injection volume and maximum injection volume are reduced. Pass condition detected
P0180 Fuel Temperature Sensor "A" Circuit The fuel temperature is fixed at a specified value. Pass condition detected
P0182 Fuel Temperature Sensor "A" Circuit Low Input The fuel temperature is fixed at a specified value. Pass condition detected
P0183 Fuel Temperature Sensor "A" Circuit High Input
[Fuel temperature sensor high input]
The fuel temperature is fixed at a specified value. Pass condition detected
P0190 Fuel Rail Pressure Sensor Circuit
·

The main and sub circuits of the fuel pressure sensor are malfunctioning:

·

The engine power is reduced by 90%.*


·

The main or sub circuit of the fuel pressure sensor is malfunctioning:

·

The engine power is limited.



Ignition switch off
P0191 Fuel Rail Pressure Sensor Circuit Range / Performance
·

The main and sub circuits of the fuel pressure sensor are malfunctioning:

·

The engine power is reduced by 90%.*


·

The main or sub circuit of the fuel pressure sensor is malfunctioning:

·

The engine power is limited.



Ignition switch off
P0192 Fuel Rail Pressure Sensor Circuit Low Input
·

The main and sub circuits of the fuel pressure sensor are malfunctioning:

·

The engine power is reduced by 90%.*


·

The main or sub circuit of the fuel pressure sensor is malfunctioning:

·

The engine power is limited.



Ignition switch off
P0193 Fuel Rail Pressure Sensor Circuit High Input
·

The main and sub circuits of the fuel pressure sensor are malfunctioning:

·

The engine power is reduced by 90%.*


·

The main or sub circuit of the fuel pressure sensor is malfunctioning:

·

The engine power is limited.



Ignition switch off
P0201 Injector Circuit / Open - (Cylinder 1) The engine power is limited. Ignition switch off to ON or STA on
P0202 Injector Circuit / Open - (Cylinder 2) The engine power is limited. Ignition switch off to ON or STA on
P0203 Injector Circuit / Open - (Cylinder 3) The engine power is limited. Ignition switch off to ON or STA on
P0204 Injector Circuit / Open - (Cylinder 4) The engine power is limited. Ignition switch off to ON or STA on
P0234 Turbocharger / Supercharger Overboost Condition The engine power is limited. Pass condition detected
P0335 Crankshaft Position Sensor "A" Circuit The engine power is reduced by 90%.* Pass condition detected
P0340 Camshaft Position Sensor "A" Circuit (Bank 1 or Single Sensor) The engine power is reduced by 90%.* Pass condition detected
P0400 Exhaust Gas Recirculation Flow The engine power is limited. Ignition switch off
P0405 Exhaust Gas Recirculation Sensor "A" Circuit Low The engine power is limited. Ignition switch off
P0406 Exhaust Gas Recirculation Sensor "A" Circuit High The engine power is limited. Ignition switch off
P042E Exhaust Gas Recirculation "A" Control Stuck Open The engine power is limited. Ignition switch off
P0488 Exhaust Gas Recirculation Throttle Position Control Range/Performance The engine power is limited. Ignition switch off
P0489 Exhaust Gas Recirculation Control Circuit Low The engine power is limited. Ignition switch off
P0490 Exhaust Gas Recirculation Control Circuit High The engine power is limited. Ignition switch off
P0500 Vehicle Speed Sensor "A" The vehicle speed is fixed at 0 km/h (0 mph). Pass condition detected
P0606 ECM / PCM Processor The engine power is reduced by 90%.* Pass condition detected
P060A Internal Control Module Monitoring Processor Performance The engine power is reduced by 90%.* Pass condition detected
P0627 Fuel Pump Control Circuit / Open The engine power is limited. Pass condition detected
P062D Fuel Injector Driver Circuit Performance Bank 1
·

1 malfunctioning cylinder detected:

·

The engine power is limited.



·

2 or more malfunctioning cylinders detected:

·

Stalls the engine.



Ignition switch off
P1229 Fuel Pump System The engine power is limited. Ignition switch off
P1251 Turbocharger / Supercharger Overboost Condition (Too High) The engine power is limited. Ignition switch off
P1271 Fuel Regulator Circuit Malfunction (EDU Drive) The engine power is limited. Ignition switch off
P1272 Fuel Pressure Regulator Malfunction The engine power is limited. Ignition switch off
P1626 Idle Signal Output Value Too Low The engine power is limited. Ignition switch off
P1627 Idle Signal Output Value Too High The engine power is limited. Ignition switch off
P2120 Throttle/Pedal Position Sensor/Switch "D" Circuit The engine power is limited. Ignition switch off
P2121 Throttle/Pedal Position Sensor/Switch "D" Circuit Range/Performance The engine power is limited. Ignition switch off
P2122 Throttle/Pedal Position Sensor/Switch "D" Circuit Low Input The engine power is limited. Ignition switch off
P2123 Throttle/Pedal Position Sensor/Switch "D" Circuit High Input The engine power is limited. Ignition switch off
P2125 Throttle/Pedal Position Sensor/Switch "E" Circuit The engine power is limited. Ignition switch off
P2127 Throttle/Pedal Position Sensor/Switch "E" Circuit Low Input The engine power is limited. Ignition switch off
P2128 Throttle/Pedal Position Sensor/Switch "E" Circuit High Input The engine power is limited. Ignition switch off
P2138 Throttle/Pedal Position Sensor/Switch "D"/"E" Voltage Correlation The engine power is limited. Ignition switch off
P2141 Diesel Throttle Motor Circuit Low The engine power is limited. Ignition switch off
P2142 Diesel Throttle Motor Circuit High The engine power is limited. Ignition switch off
P2226 Barometric Pressure Circuit The atmospheric pressure is fixed at a specified value. Pass condition detected
P2228 Barometric Pressure Circuit Low Input The atmospheric pressure is fixed at a specified value. Pass condition detected
P2229 Barometric Pressure Circuit High Input The atmospheric pressure is fixed at a specified value. Pass condition detected

HINT:

*: Engine power is limited immediately after the DTC is stored.