Home › Engine / Hybrid System › 2AD-FTV FUEL › FUEL SENDER GAUGE ASSEMBLY
RM3090E _51 Engine / Hybrid System _008735 2AD-FTV FUEL _0049731 FUEL SENDER GAUGE ASSEMBLY G

2AD-FTV FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

A209232
1.344,2.406 0.531,2.406 false 1.125,3.135 0.448,3.135 false 1.281,3.927 0.573,3.927 false 0.281,2.313 0.563,2.49 0.281,0.177 10 false *1 0.198,3.021 0.51,3.177 0.313,0.156 10 false *2 0.313,3.823 0.625,3.979 0.313,0.156 10 false *3 0.115,0.177 0.427,0.333 0.313,0.156 10 false *a
*1 F (Upper)
*2 1/2
*3 E (Lower)
*a Component without harness connected
(Fuel Sender Gauge Assembly)


a.

Check that the float moves smoothly between F and E.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Float level is F (upper) 13.5 to 16.5 Ω
1 - 2 1/2 200.3 to 224.7 Ω
1 - 2 Float level is E (lower) 405.5 to 414.5 Ω


If the result is not as specified, replace the fuel sender gauge assembly.