Home › Engine / Hybrid System › 3ZR-FE INTAKE / EXHAUST › INTAKE MANIFOLD
RM3090E _51 Engine / Hybrid System _008408 3ZR-FE INTAKE / EXHAUST _0046965 INTAKE MANIFOLD G

3ZR-FE INTAKE / EXHAUST  INTAKE MANIFOLD  INSPECTION  


PROCEDURE

Hide 17111 1.INSPECT INTAKE MANIFOLD

a.
A173126

Inspect the diaphragm.

i.

Using a vacuum pump, apply a vacuum of 60 kPa (450 mmHg, 17.7 in.Hg) or higher to the diaphragm chamber. Wait for 1 minute and check that the needle of the vacuum pump does not lower.

If the result is not as specified, replace the intake manifold.



b.

After applying vacuum in the step above, check that the actuator rod operates.


c.

Check that the vacuum hose is not clogged.

If the result is not as specified, replace the vacuum hose.