Home › Engine / Hybrid System › 2AD-FHV STARTING › RELAY
RM3090E _51 Engine / Hybrid System _008739 2AD-FHV STARTING _0049810 RELAY G

2AD-FHV STARTING  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 28300 1.INSPECT STARTER RELAY (ST)

a.
A291372
1.677,0.75 2.01,0.75 true 2.604,0.75 2.938,0.75 true 2.438,1.125 2.938,1.125 true 2.448,1.604 2.948,1.604 true 0.271,0.75 0.427,0.948 0.156,0.198 10 5 0.271,1.281 0.427,1.479 0.156,0.198 10 1 1.188,1.292 1.344,1.49 0.156,0.198 10 2 1.188,0.76 1.344,0.958 0.156,0.198 10 3 2.969,0.656 3.125,0.854 0.156,0.198 10 2 1.594,0.656 1.75,0.854 0.156,0.198 10 1 2.969,1.51 3.125,1.708 0.156,0.198 10 3 2.969,1.042 3.125,1.24 0.156,0.198 10 5

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the starter relay.


Hide 28610 2.INSPECT GLOW PLUG RELAY

a.
A291373

Disconnect the glow plug relay connector.


b.

Detach the clamp and remove the glow plug relay.


c.
A201709
1.833,0.417 2,0.417 2,0.417 2.292,1.135 true 3,0.417 2.833,0.417 2.833,0.417 2.583,1.135 true 1.833,1.833 2,1.833 2,1.833 2.292,1.365 true 3,1.833 2.833,1.833 2.833,1.833 2.594,1.365 true 0.417,1.219 0.573,1.417 0.156,0.198 10 4 1.271,1.219 1.427,1.417 0.156,0.198 10 3 1.271,0.813 1.427,1.01 0.156,0.198 10 2 0.417,0.802 0.573,1 0.156,0.198 10 1 1.729,0.333 1.885,0.531 0.156,0.198 10 4 3.031,0.333 3.188,0.531 0.156,0.198 10 3 3.042,1.74 3.198,1.938 0.156,0.198 10 2 1.74,1.74 1.896,1.938 0.156,0.198 10 1

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Battery voltage not applied to terminals 3 and 4 10 kΩ or higher
Battery voltage applied to terminals 3 and 4 Below 1 Ω


If the result is not as specified, replace the glow plug relay.