Home › Engine / Hybrid System › 2AD-FHV FUEL › FUEL SUPPLY PUMP
RM3090E _51 Engine / Hybrid System _008734 2AD-FHV FUEL _0049856 FUEL SUPPLY PUMP G

2AD-FHV FUEL  FUEL SUPPLY PUMP  INSPECTION  


PROCEDURE

Hide 22100 1.INSPECT FUEL SUPPLY PUMP ASSEMBLY

a.

Inspect the suction control valve assembly.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 1.9 to 2.3 Ω


HINT:

The temperature indicated in "Condition" is the temperature of the suction control valve.


If the result is not as specified, replace the suction control valve assembly.



b.

Inspect the fuel temperature sensor.

Click hereEngine / Hybrid System>2AD-FHV FUEL>FUEL TEMPERATURE SENSOR>INSPECTION

If the result is not as specified, replace the fuel temperature sensor.