Home › Engine / Hybrid System › 2AD-FHV FUEL › COMMON RAIL
RM3090E _51 Engine / Hybrid System _008734 2AD-FHV FUEL _0049857 COMMON RAIL G

2AD-FHV FUEL  COMMON RAIL  INSPECTION  


PROCEDURE

Hide 23810A 1.INSPECT COMMON RAIL ASSEMBLY

a.
A114886
1.323,0.719 1.063,0.5 1.063,0.5 0.896,0.5 false 1.719,1.188 1.719,1.677 false 1.323,1.167 1.063,1.385 1.063,1.385 0.896,1.385 false 2.135,0.719 2.396,0.5 2.396,0.5 2.563,0.5 false 2.135,1.167 2.396,1.385 2.396,1.385 2.563,1.385 false 1.719,0.656 1.719,0.125 1.719,0.125 1.833,0.125 false 0.542,0.406 0.833,0.583 0.292,0.177 10 E2S 1.865,0.031 2.177,0.208 0.313,0.177 10 PR2 2.604,0.406 2.917,0.573 0.313,0.167 10 VCS 0.615,1.292 0.844,1.438 0.229,0.146 10 VC 1.625,1.719 1.885,1.896 0.26,0.177 10 PR 2.604,1.292 2.854,1.458 0.25,0.167 10 E2 0.104,0.083 0.417,0.24 0.313,0.156 10 *a
*a Component without harness connected
(Fuel Pressure sensor)


Inspect the fuel pressure sensor.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 (PR) - 4 (E2) Always 16.4 kΩ or less
2 (PR2) - 3 (E2S) Always 16.4 kΩ or less
6 (VC) - 5 (PR) Always 3 kΩ or less
1 (VCS) - 2 (PR2) Always 3 kΩ or less


HINT:

Perform the inspection with no fuel pressure applied.


If the result is not as specified, replace the common rail assembly.



b.

Inspect the pressure discharge valve.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.96 to 1.16 Ω


HINT:

The temperature indicated in "Condition" is the temperature of the pressure discharge valve.


If the result is not as specified, replace the common rail assembly.