Home › Vehicle Interior › DOOR LOCK › BACK DOOR LOCK › 2012.12–2015.10
RM3090E _58 Vehicle Interior _008782 DOOR LOCK _0049895 BACK DOOR LOCK A

DOOR LOCK  BACK DOOR LOCK  INSTALLATION  


PROCEDURE

Hide 69350 1.INSTALL BACK DOOR LOCK ASSEMBLY

NOTICE:
·

When installing a new back door lock assembly, if there is anytape stuck to it, remove the tape.

·

When installing a new back door lock assembly, if there are anystrings attached to it, cut the strings off.

·

Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.



a.

Apply MP grease to the sliding parts of the back door lock assembly.


b.
B339882

w/ Power Back Door:

i.

Attach the clamp to install the back door lock assembly.


ii.

Install the 4 bolts.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


iii.

Connect the connector.



c.
B337030

w/o Power Back Door:

i.

Install the back door lock assembly with the 3 bolts.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


ii.

Connect the connector.



Hide 67750 2.INSTALL BACK DOOR TRIM BOARD ASSEMBLY

Hide 67938A 3.INSTALL BACK DOOR SIDE GARNISH LH

Hide 67937B 4.INSTALL BACK DOOR SIDE GARNISH RH

Hide 67939B 5.INSTALL BACK DOOR GARNISH CENTER