Home › Engine / Hybrid System › 2AD-FTV ENGINE CONTROL › ECD SYSTEM(for DPF)
RM3090E _51 Engine / Hybrid System _008377 2AD-FTV ENGINE CONTROL _0046807 ECD SYSTEM(for DPF) C

2AD-FTV ENGINE CONTROL  ECD SYSTEM(for DPF)  P0630  VIN not Programmed or Mismatch - ECM / PCM  


DESCRIPTION

DTC P0630 is set when the Vehicle Identification Number (VIN) is not stored in the ECM or the input VIN is not accurate. Input the VIN with the GTS.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0630 VIN not Programmed or Mismatch - ECM / PCM VIN not stored in ECM
Input VIN in ECM not accurate (1 Trip detection logic).
ECM Comes on DTC stored

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0630)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS ON.


c.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 61

d.

Read the DTCs.

Result:
Proceed to
DTC P0630 is output
DTC P0630 and other DTCs are output


NOTICE:

If P0630 is set, the VIN must be input to the ECM using the GTS. However, all DTCs are cleared automatically by the GTS when inputting the VIN. If DTCs other than P0630 are set, check them first.


HINT:

If any DTCs other than P0630 are output, troubleshoot those DTCs first.




DTC P0630 is output

2.INPUT VIN WITH GTS

DTC P0630 and other DTCs are output

2.INPUT VIN WITH GTS

Result:
Proceed to
NEXT



NEXT

END