Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
87103B
1.INSTALL BLOWER WITH FAN MOTOR SUB-ASSEMBLY
Install the blower motor with fan sub-assembly with the 3 screws.
Connect the connector.
w/ PTC Heater:
Connect the connector bracket with the screw.
55607
2.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY