Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
88625Q
1.INSTALL COOLER (ROOM TEMPERATURE SENSOR) THERMISTOR
Connect the connector and aspirator pipe to the cooler (room temperature sensor) thermistor.
Attach the 2 claws to install the cooler (room temperature sensor) thermistor.
55012A
2.INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55900
3.INSTALL AIR CONDITIONING CONTROL ASSEMBLY
55411G
4.INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL
5.INSTALL NAVIGATION RECEIVER (w/ Navigation System)
86120
6.INSTALL RADIO RECEIVER ASSEMBLY (w/ Radio Receiver)
55521C
7.INSTALL STEREO OPENING COVER (w/o Audio)
55680A
8.INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
55670
9.INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
55412C
10.INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL